Axxess AXDSPL-WR Manuale di istruzioni per l'installazione - Pagina 3
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Automobile Accessories Axxess AXDSPL-WR. Axxess AXDSPL-WR 20. 6-channel digital signal processor with water resistant enclosure
Stampa la pagina
1. Install the AXDSPL-WR harness and make all necessary connections to the radio and
vehicle, but leave the amp turn-on wire disconnected.
2. With the arrow stamped onto the cap facing upwards, push the 16-pin connector from
the AXDSPL-WR harness harness into the left side of the cap. The locking clip on the
connector should face upward. Make sure the gasket is seating properly in the cap.
(Figure A)
3. With the arrow stamped onto the cap still facing upwards, push the 20-pin connector
from the AXDSPL-WR harness into the right side of the cap. The locking clip on the
connector should face upward. Make sure the gasket is seating properly in the cap.
(Figure A)
4. Plug the 16-pin and 20-pin connectors from the AXDSPL-WR harness into the AXDSP-L
circuit board. (Figure A)
5. Slide the assembly into the case, then click it shut. Zip-tie the enclosure to a secure
location. Make sure the Axxess logo is facing up to further ensure that no outside
elements can enter the enclosure.
INSTALLATION
Continued on the next page
Case
AXDSP-L
Circuit Board
Cap (with O-ring)
16-Pin
Gasket
AXDSP L
Harness
(Figure A)
Zip-tie Mounts
20-Pin
REV. 11/3/2020 INSTAXDSPL-WR
3