Axxess AX-FT901 Manuale - Pagina 2

Sfoglia online o scarica il pdf Manuale per Elettronica per autoveicoli Axxess AX-FT901. Axxess AX-FT901 8. Fiat 500 2015 / 500l 2014(with u-connect) data interface with swc & factory display retention †

Stampa la pagina

From the aftermarket radio to the AX-FT901 harness:

• Connect the Black wire to the ground wire.

• Connect the Yellow wire to the battery wire.

• Connect the Red wire to the accessory wire.

• If the aftermarket radio has an illumination wire, connect the Orange wire to it.

• Connect the Blue wire to the power antenna turn-on wire.

• Connect the White wire to the left front positive speaker wire.

• Connect the White/Black wire to the left front negative speaker wire.

• Connect the Gray wire to the right front positive speaker wire.

• Connect the Gray/Black wire to the right front negative speaker wire.

• Connect the Green wire to the left rear positive speaker wire.

• Connect the Green/Black wire to the left rear negative speaker wire.

• Connect the Purple wire to the right rear positive speaker wire.

• Connect the Purple/Black wire to the right rear negative speaker wire.

The following (3) wires are only for multimedia/navigation radios that require these wires.

• Connect the Blue/Pink wire to the VSS/speed sense wire.

• Connect the Green/Purple wire to the reverse wire.

• Connect the Light Green wire to the parking brake wire.

CONNECTIONS TO BE MADE

From the aftermarket radio to the ASWC-1 harness:

This harness is only to be used if the vehicle is equipped with steering wheel controls or a backup camera.

• Connect the Red wire to the accessory wire.

• For the radios listed below, connect the female 3.5mm connector with stripped leads, to the

male 3.5mm SWC jack from the ASWC-1 harness. Any remaining wires tape off and disregard:

• Eclipse: Connect the steering wheel control wire, normally Brown, to the Brown/

White wire of the connector. Then connect the remaining steering wheel control wire,

normally Brown/White, to the Brown wire of the connector.

• Metra OE: Connect the steering wheel control Key 1 wire (Gray) to the Brown wire.

• Kenwood or select JVC with a steering wheel control wire: Connect the Blue/Yellow

wire to the Brown wire.

• XITE: Connect the steering wheel control SWC-2 wire from the radio to the Brown wire.

• Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the AX-SWC-PARROT (sold

separately), and then connect the 4-pin connector from the AX-SWC-PARROT into the radio .

Note: The radio must be updated to rev. 2.1.4 or higher software.

•

Connect the steering wheel control wire, referred to as

Universal "2 or 3 wire" radio:

Key-A or SWC-1, to the Brown wire of the connector. Then connect the remaining

steering wheel control wire, referred to as Key-B or SWC-2, to the Brown/White wire of

the connector. If the radio comes with a third wire for ground, disregard this wire.

Note: After the interface has been programmed to the vehicle, refer to the manual

provided with the radio for assigning the SWC buttons. Contact the radio manufacturer

for more information.

Continued on the next page