Axxess RFASWC Manuale di istruzioni per l'installazione - Pagina 3
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Elettronica per autoveicoli Axxess RFASWC. Axxess RFASWC 12. Wireless swc universal add-on
Anche per Axxess RFASWC: Manuale di istruzioni per l'installazione (12 pagine)
Stampa la pagina
Wiring The OESWC Interface
1. Connect the red wire to 12 volt accessory
2. Connect the Black wire to ground (you may use the same ground that
you use for the aftermarket radio)
If you are using an Eclipse or Kenwood radio, plug the female 3.5mm
connector with the Brown and Brown/White wires into the male 3.5mm
connector of the ASWC harness.
* For Kenwood radios: Connect the Kenwood SWC wire (normally Blue/
Yellow) to the Brown wire of the ASWC. Isolate and tape the Brown/White
wire, it will not be used.
* Kenwood Models: The following three models, DNX9960, DNX7160,
and DDX896, need a 10k to 12k ohm resistor between the Blue/Yellow of
the Kenwood and the Brown wire of the female 3.5 during programming.
After programming remove the resistor and reconnect the Blue/Yellow
and brown wire.
* For Eclipse radios: Connect the Eclipse SWC wires (Normally Brown
and Brown/Black) to the Brown and Brown/White wires of the ASWC.
Brown goes to Brown and Brown/White goes to Brown/Black.
Setting Up the RFASWC
1. Press the Red and Green buttons simultaneously for 5 seconds, and
then press volume up for two seconds. This will orientate your button
direction.
2