DigiDesign 96 I Manuale - Pagina 17

Sfoglia online o scarica il pdf Manuale per Apparecchiature di registrazione DigiDesign 96 I. DigiDesign 96 I 19. Version 8.0

Replacing an I/O Card

To replace a card:

Power off and disconnect the 96 I/O from

your Pro Tools|HD system.

Make sure that the 96 I/O AC cord remains

plugged in so that it is grounded.

Remove all 16 of the small Phillips-head

screws around the edges of the top cover. Put the

screws in a safe place.

Lift off the top of the 96 I/O and set it aside.

If the card you are replacing is still connected

to the 96 I/O, see "Removing an I/O Card" on

page 11.

To discharge any static electricity, touch the

power supply casing. It is a good idea to do this

often, throughout the process.

Look into the empty bay to locate the guide

rails for the card

Example of an empty bay. Note guide rails along the

inside edge

Placing the edge of the card into the guide rails

Slide the edges of the card into the guide rails

on each side of the bay. Push the card all the way

in until the card's faceplate is nearly flush with

the rear panel of the 96 I/O.

Screw the card's faceplate onto the rear panel

surface of the 96 I/O with the same screws you

removed from the empty bay cover.

Locate the raised ridge in the middle of the

50-pin cable which connects to the 96 I/O chas-

sis. This ridge is only on one side of the connec-

tor, and there is a matching groove on only one

side of the 50-pin connector on the card.

Locating the ridge on the 50-pin cable and the matching

groove on the 50-pin connectors on the card

Appendix A: Card Removal and Replacement