Epson 570e - LQ B/W Dot-matrix Printer Manuale informativo sul prodotto - Pagina 13
Sfoglia online o scarica il pdf Manuale informativo sul prodotto per Stampante Epson 570e - LQ B/W Dot-matrix Printer. Epson 570e - LQ B/W Dot-matrix Printer 18. Warranty statement
Anche per Epson 570e - LQ B/W Dot-matrix Printer: Manuale di riferimento rapido (15 pagine), Specifiche tecniche (2 pagine), Garanzia limitata (1 pagine)
Stampa la pagina
5. Replace the paper tension unit by lowering it onto the
mounting pegs. Then press down both ends of the unit
until it clicks into place.
6. Replace the paper guide and the printer cover. Then close
the paper guide cover.
The top-of-form position is where the printer will start printing
on the page. If your printing appears too high or low, follow the
steps below to use the micro adjust feature to adjust the top-of-
form position.
1. Make sure the printer is turned on.
2. If necessary, load paper as described earlier. If you load
paper onto the push tractor, press the
advance the paper to the current top-of-form position.
3. Lift the printer cover up and off the printer.
4. Hold down the
button for about 3 seconds. The
Pause light starts flashing and the printer enters the micro
adjust mode.
5. Press the
up on the page, or press the
the top-of-form position down on the page.
To adjust the top-of-form position for continuous paper
loaded on the pull tractor, see the following example:
First mark a point 0.26 inch (6.5 mm) above the paper's
perforation; then position the paper so that the mark is even
with the top edge of the plastic ribbon cover. This gives you
a 0.33-inch (8.5-mm) margin on the next page, meaning
button to
the printer starts printing 0.33 inch (8.5 mm) below the
perforation. If you mark a point 0.22 inch (5.5 mm) above
the perforation, you get a 0.37-inch (9.5-mm) margin on
the next page.
6. After you set the top-of-form position, press the
button to exit micro adjust mode.
4/00
EPSON LQ-570e
D button to move the top-of-form position
U button to move
EPSON LQ-570e
- 13