Epson 570e - LQ B/W Dot-matrix Printer Manuale informativo sul prodotto - Pagina 16

Sfoglia online o scarica il pdf Manuale informativo sul prodotto per Stampante Epson 570e - LQ B/W Dot-matrix Printer. Epson 570e - LQ B/W Dot-matrix Printer 18. Warranty statement
Anche per Epson 570e - LQ B/W Dot-matrix Printer: Manuale di riferimento rapido (15 pagine), Specifiche tecniche (2 pagine), Garanzia limitata (1 pagine)

Epson 570e - LQ B/W Dot-matrix Printer Manuale informativo sul prodotto
EPSON LQ-570e
2. While holding down the
It enters the bidirectional adjustment mode, then prints
instructions and the first set of alignment patterns.
3. As described in the instructions, compare the alignment
patterns and select the pattern with the best alignment.
4. Follow the instructions to print the remaining sets of
alignment patterns and select the pattern with the best
alignment in each set.
5. After you select the best pattern in the final set of alignment
patterns, turn off the printer and exit the bidirectional
adjustment mode. Your selections are saved automatically.
Running the self test helps you determine whether the printer
or the computer is causing a printing problem. You can print
the self test using either single sheets or continuous paper.
1. Make sure paper is loaded and the printer is turned off.
2. To run the test using the Draft font, hold down the
button while you press the
printer. To run the test using the printer's letter-quality
fonts, hold down the
the printer. Either self test can help you determine the
source of your printing problem; however, the draft test
prints faster than the letter-quality test.
After a few seconds, the printer loads the paper
automatically and begins printing the self test. A series of
characters is printed.
3. To end the self test, press the
and the
button to eject the printed page. Then
turn off the printer.
If the self test results are satisfactory, the printer is working
properly and the problem probably results from your printer
driver settings, application settings, computer, or interface
cable. (Be sure to use a shielded interface cable.)
If the self test does not print properly, there is a problem with
the printer.
16 - EPSON LQ-570e
button, turn on the printer.
button to turn on the
button while you turn on
button to stop printing
If you are an experienced user or a programmer, you can print a
hexadecimal dump to isolate communication problems between
the printer and your software program. In hex dump mode, the
printer prints all data received from the computer as
hexadecimal values.
You can print a hex dump using either single sheets or
continuous paper.
1. Make sure paper is loaded and the printer is turned off.
2. To enter hex dump mode, hold down both the
buttons while you turn on the printer.
3. Open a software application and send a print job to the
printer. Your printer prints all the codes it receives in
hexadecimal format.
If characters are printable, they appear in the right column
as ASCII characters. Nonprintable codes, such as control
codes, are represented by dots. By comparing the characters
printed in the right column with the printout of the
hexadecimal codes, you can check the codes the printer is
receiving.
4. To exit hex dump mode, press the
printing and the
page(s). Then turn off the printer.
4/00
and
button to stop
button to eject the printed