DigiDesign VENUE XO16 Manuale - Pagina 9
Sfoglia online o scarica il pdf Manuale per Apparecchiature di registrazione DigiDesign VENUE XO16. DigiDesign VENUE XO16 12. Analog/digital output card for venue mix rack and venue sc48
Stampa la pagina
Completing and Confirming Installation
To complete and confirm installation:
Reattach the Mix Rack's front panel.
1
Reconnect the power and any audio cables to the Mix Rack.
2
Turn on the system.
3
Go to the Options page and click the Devices tab to view
4
your system hardware status. The newly installed XO16 Card
should be displayed.
If the Expansion Card does not appear in the Mix Rack
graphic, check the ribbon cable connection. Disconnect and
reconnect the ribbon cable to the Expansion Card, making
sure to properly seat the connector in its card socket.
\
Detail of Devices tab indicating presence of one XO16 Card
Go to the Patchbay page and click the Stage tab to verify
5
that the XO16 card appears in the patchbay. The XO16's ana-
log outputs appear under "Analog Card D." The digital out-
puts appear under "Digital Card E."
In the standalone software, right-click the Mix Rack graphic
6
to see and modify your Mix Rack's input and output card con-
figuration. XO16 Cards appear as "Analog/Digital Output
Card" in the pop-up menu.
Detail of standalone software's Devices tab pop-up menu showing XO16
Card in Slot E of Mix Rack
Installing an XO16 Card in SC48
Your SC48 has two available output card slots, slots D and E.
These instructions assume you already have an output card in-
stalled in slot D and that slot E is empty.
If you are replacing an XO16 Card or you want to install
two in your SC48, you must first remove an output card. See
the VENUE SC48 Service Guide for more information on
replacing or removing cards.
Shut down your system, and turn off power to the SC48.
1
Disconnect any power cables from the SC48, as well as any
2
other audio cables that may get in your way.
On the back panel of the SC48, locate output slot E.
3
Slot E (remove card slot cover)
Left side of the SC48 back panel
Remove the four screws holding the card slot cover in place.
4
You can use a flathead screwdriver to pry the cover away from
the output slot after removing the screws.
Use care when prying away the card slot cover. The ribbon
cable that you connect to the output card is attached to the
inside of the card slot cover.
Keep the screws nearby for securing the card to the SC48.
Clip the cable tie to free the ribbon cable that is attached to
5
the inside of the card slot cover.
Clip the cable tie to free the ribbon cable
Chapter 2: Installing the XO16 Card 5