Epson ActionPrinter 3260 s Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Stampante Epson ActionPrinter 3260 s. Epson ActionPrinter 3260 s 15. Epson actionprinter 3260: product information

Stampa la pagina

Action Printer 3260

Changing the default settings

If you need to change default settings that cannot be changed

by using your software program, you press the control panel

buttons, and the control panel lights show your selections.

Follow the steps below to make your changes:

Note:

You can repeat steps 5 through 7 if you want to make more than

one change. Also, you can turn off the printer and start over if you

are not sure about a setting.

1. Make sure the printer is turned off and paper is loaded in

the paper cassette. If you installed the optional push

tractor, you can use continuous paper for the

default-setting mode.

2. To enter the default-setting mode, hold down the FONT

button while you turn on the printer.

The printer automatically loads a sheet of paper and prints

out instructions and a table showing you the languages

from which you can choose. You can print the

default-setting mode messages in English, French,

German, Italian, or Spanish.

3. Press the FONT button until the FONT lights indicate the

language of your choice; then press the FF button to make

your selection.

FONT lights

Language

English

0 on

Once you press the FF button, the printer prints the current

default settings and further instructions in the selected

language. After printing is finished, go to the next step.

4. If you want more help text to be printed, press the FONT

button. After printing is finished, go to the next step.

If you do not want to print additional help text, press the

FF button and go to the next step immediately.

AP-3260-6

READY

1/94

Note:

When you first use the default-setting mode, it is a good idea to

press the FONT button to print the help text before changing

default settings. The printed text guides you through the

operation. Once you are familiar with the operation, press the

button to skip printing.

5. Use the following table to choose the setting you want to

change. Then press the FONT button as many times as

necessary until the FONT lights match your selection.

Default-setting

FONT lights

Graphic print

direction

Download

Skip over

perforation

Tear-off position 1 0 0 I Above cutter I On cutter

I 0

Auto line feed

Hex dump/

demonstration

Character table I

Page length

(for continuous

paper)

TOF position

0 on

See the following tables in this section.

For example, if you want to change the character table, press

the FONT button until the left FONT light is flashing and

the right FONT light is on.

6. Press the FF button to change the setting. The READY light

turns on or off to show your selection, as indicated above.

Your new setting is saved automatically and remains in

effect until you change it.

If you are changing the character table, page length, or TOF

(top-of-form) position, go to step 7 next. Otherwise, go to

step 8.

7. If you are changing the character table, page length, or TOF

position, you must make additional changes as shown in

the tables below. Press the FF button until the set of lights

(the FONT lights and the READY light) indicate your

selection. Then press the FONT button to set the setting.

Once you press the FONT button, the printer advances to the

next item in the previous table and your setting is saved

automatically. The new setting remains in effect until you

change it.

STATUS

READY light

Bidirectional

Unidirectional

Off

I Off

Demo.

Hex dump

Change*

Change'

No change'

24-Pin Printers