Archer Components D1X Istruzioni per l'installazione e la configurazione - Pagina 2
Sfoglia online o scarica il pdf Istruzioni per l'installazione e la configurazione per Accessori per biciclette Archer Components D1X. Archer Components D1X 2.
Stampa la paginaShifter Prep - P Straps
1. Insert the narrow end of each P-strap into the front slot-holes. Pull snug.
2. Loosely thread the M2.5 screws through the mounting bosses, into the aluminum clamps.
Install
1. Thread the shift cable into the insertion point on your rear derailleur.
2. Align the far end of the bowden housing ferrule into the derailleur.
3. Pull the shift cable snug.
4. Locate the shifter in the desired location on the chainstay.
5. Pull the P-straps over the chainstay and through the clamp slot on the mounting boss.
6. Push the shifter up against the chainstay while pulling the p-straps tight and tightening
the clamp screws.
7. Thread the shift cable through the derailleur path but DO NOT TIGHTEN the shift cable
against the derailleur.
Configure
1. Turn on the shifter by pressing the tactile switch for 1 second.
2. The red light on the shifter will flash.
3. If you hear motor oscillations, slightly tug the shifter cable. The motor will quiet down.
4. Open the Archer app.
5. Find the device labeled either Archer_D1x or D1x_######.
6. Pair with the device if prompted.
7. Press New Configuration and proceed through the prompts on the app.
INSIDE LEFT
(room for images?)
STEP 3: REMOTE INSTALLATION
Battery
1. Remove the two M2 screws from the battery door cover.
2. Insert the battery.
3. Check that the 37x1.5mm o-ring is properly seated.
4. Close the door and tighten the screws.
Handlebar
1. Remove your old shifter pod and any leftover mounting hardware.
2. Remove your handle bar grip.
3. Slide on the SRAM matchmaker clamp over.
4. Use the provided M5 screw to secure the remote to the clamp.
5. Adjust the location of the remote and fully tighten the clamp.
STEP 4: REMOTE/SHIFTER PAIRING
1. Make sure the remote is powered off.
2. Power on the shifter and pair with the mobile app.
3. Go to Settings > Pair Remotes > Proceed. The shifter will turn off automatically.
4. Turn the shifter back on. An orange LED will be flashing indicating Remote Learn Mode.
5. Turn on the remote, The LED will flash green 2 times, then orange. Once the orange light
has stopped flashing the remote has been uniquely paired to the shifter.
6. You do not need to do Remote/Shifter pairing each time you ride your bike. Once
they've been programmed you can simply turn on the shifter and remote and they will
automatically connect, pair and bond.
INSIDE RIGHT
(room for images?)