Archgard Burner Media Manuale di installazione - Pagina 2

Sfoglia online o scarica il pdf Manuale di installazione per Accessori per caminetti Archgard Burner Media. Archgard Burner Media 16.

Stampa la pagina
1.0 Important Information
The following information applied for all media installation options.
WARNING
IMPORTANT
Gas and vent connection must be made before installing burner media.
Before you begin:
•
Ensure the fireplace is OFF and cool before servicing the fireplace
•
Ensure the gas supply is turned OFF and disconnect the power supply (including backup batteries)
•
Remove barrier screen or decorative front*
•
Remove the valve blind (recommended)*
•
Remove glass door*
* See the Installation, Operation, and Maintenance Manual included with the fireplace.
CAUTION: DO NOT block pilot opening with burner media.
NOTE: Improper placement of burner media may cause soot accumulation on the internal parts and glass. This is not covered under
warranty. Do not use damaged media.
The Kojin 50 offers dozens of potential media installation combination options. Burner media may be mixed, and silhouette logs may be
placed in almost any configuration or used with any media type.
There are only few common restrictions:
1.
The secondary air channels on the left and right side of the burner may not be blocked.
2.
The pilot opening must not be blocked
3.
If placing Silhouette logs, they should not be placed directly on the burner ports - use the logs to bridge the burner instead.
4.
The Grand Timber and Silver Birch log sets must be installed as shown.
5.
Only use approved burner media.
Figure 1.0.01: Secondary Air Openings
2

General Information

Failure to position the burner media in accordance with the this manual, or failure to use only parts
specifically approved with this appliance, may result in property damage or personal injury. Never use
unapproved burner media such as rock wool or similar material. The use of unapproved burner media may
cause damage or injury and will void product warranty.
When burner media around the pilot shield take care to not block the pilot opening. Failure to keep
the opening clear of media will cause a delayed ignition. Media should also be placed so they do not
completely block burner ports. DO NOT block secondary air gaps at the sides of the burner.
Figure 1.0.02: Do not block pilot