CREE LIGHTING ZR22RK Istruzioni per l'installazione - Pagina 3

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Lanterna CREE LIGHTING ZR22RK. CREE LIGHTING ZR22RK 5. Led retrofit troffer kit, standard and emergency luminaires

Stampa la pagina

Retrofit Main Assembly

Bracket

Retrofit Side Panel Latch

3 of 5

Safety Cable

Sliding End

Cap

Edge of Side Panel insert into

Existing Troffer Pan

Lens

Ground Wire

STEP 5:

Remove the pink EPE plastic foam from over the LEDs by

removing each piece of blue tape.

STEP 6:

Bring the retrofit side panel up to the existing troffer pan and

connect the ground wire on the back of the side panel to the

retrofit main assembly as shown in Figure 6. Tuck the ground

lead up into the main assembly.

STEP 7:

Insert the edge of the side panel, that is opposite of latches,

between the existing troffer pan and t-grid. Then insert

the other side into the retrofit main assembly by engaging

the 2 latches on the side panel into the 2 slots on the main

assembly. See Figure 6 and 7.

NOTE: Make sure not to pinch any wires, all wires should be

tucked up inside the main assembly.

STEP 8:

Install the lens over the LEDs by putting the lens flat edge

over one side of the bracket located on the main assembly.

While pushing on the middle of the lens, to widen the lens,

insert the other flat end of the lens over the other side of the

bracket. See Figure 8 and 9.

Retrofit Side Panel

Ground Wire

Attached to Main

Retrofit Assembly

Lens

Lens Flat

Edge

Retrofit Main

Assembly Bracket

LPN00429X0001A3_B