CREE LIGHTING THE EDGE Series Avvio rapido Gude
Sfoglia online o scarica il pdf Avvio rapido Gude per Luce di lavoro CREE LIGHTING THE EDGE Series. CREE LIGHTING THE EDGE Series 2. Led flood side mount
Stampa la pagina
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions
should always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1.
To avoid the possibility of electrical shock, turn off power
supply before installation or servicing. Installation and
servicing should be performed by qualified personnel.
2.
When handling, hold fixture on sides to prevent damage to
the top screen or LED's.
3.
Product must be installed in accordance with NEC or your
local electrical code. If you are not familiar with these codes
and requirements, consult a qualified electrician.
4.
Strain relief is required for electrical connections on 2" (51
mm) adjustable fitter mounts at heights of 25' (7.6 m) and
above. Tie a knot in the supply wires above the hole in the
lower fitter wiring compartment to reduce the strain on the
connections. Make sure knot will not slip through hole.
5.
Take care to keep the LED lenses clean during installation.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
TO INSTALL:
1
Upper Fitter
"O" Ring
Lower Fitter
Supply Wire
2
(Supplied by Customer)
Puncture Membrane
of Grommet with
Supply Wires
1 of 2
Splice Compartment
Cover
Sealing
Washer
Cover Screws
Set Screws
3
Make Wire Connections and Press
Grommet into Hole in Fitter
LED Flood Side Mount
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION
MOUNTING
STEP 1:
Remove the splice compartment cover from the
lower fitter.
STEP 2:
Route the supply wires into the lower fitter wiring
compartment by puncturing the internal seal with the
supply wires.
STEP 3:
Strain relief is required for electrical connections on
the adjustable fitter mount for mount heights of 25' (7.6
m) and higher. Tie a knot in the supply wires above the
hole in the lower fitter wiring compartment to reduce
the strain on the connections. Make sure knot will not
slip through hole.
STEP 4:
Slip lower fitter over 2-3/8" (60 mm) O.D. heavy wall
pipe or tenon and securely tighten two Allen head set
screws with 3/16" Allen wrench to 18 ft. lbs. (24 N•m).
See Figure 1.
STEP 5:
Make wire connections in splice compartment of
adjustable fitter. See Figure 3, 4 and "ELECTRICAL
CONNECTION" section.
THE EDGE
®
Includes: FLD-EDG-SA
CI317X02R0_B