digigard DG85 Manuale di programmazione

Sfoglia online o scarica il pdf Manuale di programmazione per Sensori di sicurezza digigard DG85. digigard DG85 4. Outdoor high-security digital motion detector modules

Stampa la pagina

Outdoor High-Security Digital Motion Detector Modules

OPERATIONAL MODE

Digigard DG85 can function in two operational modes (see Table 4 below): DGP2 Mode or Relay Mode. When set to Relay Mode, DG85 functions as would

any standard motion detector by communicating its alarm and tamper signals via relays. When set to DGP2 Mode, DG85 functions like a DGP2 motion

detector module by communicating alarm signals, tamper signals, data and detector settings via the combus. In DGP2 Mode, both section programming and

manual programming can be used to program the settings. In Relay Mode, only manual programming can be used to program the settings (see Table 4

below). Refer to DG85's connection drawing on page 33 for the location of the DIP switches.

DIP Switch 1:OFF = Relay Mode (default)

ON = DGP2 Mode

SETTINGS

Refer to DG85's connection drawing on page 33 for the location of the DIP switches and Trimpot.

Feature

Signal Processing Mode

LED

Movement Signal Indication

Tamper Recognition

Sensitivity

Default Setting

When in DGP2 Mode only (see Operational Mode above).

When in DGP2 Mode or Relay Mode (see Operational Mode above).

This feature is always enabled in Relay Mode.

To set the sensitivity manually, remove the front cover and, using a screwdriver, turn the trimpot clockwise to increase the detector's sensitivity or

counter-clockwise to decrease it. You can turn the trimpot 360° in both directions. To determine the sensitivity setting, remove the cover and view how

many times the LED flashes. The number of times the LED flashes corresponds to the sensitivity setting. Thus if the sensitivity is set to 6, the LED will flash

6 times.

In instances where a particular setting can be set either manually or through section programming, a discrepancy may exist between the

setting of the DIP switches and the setting in the appropriate sections. In such cases, the last change that is made will dictate the setting.

For example, if you disable the LED from within section programming, the DIP switch will still show that it is enabled, however the LED is

actually disabled.

Table 4: DG85 Settings

Setting

Single

Dual

Disabled

Enabled

Disabled

Enabled

Disabled

Enabled

= 10 seconds

Digiplex & DigiplexNE - 11 - Modules Programming Guide

DG85

Programming

Section Programming

[001] [1] = OFF

DIP switch 2 = OFF

[001] [1] = ON

DIP switch 2 = ON

[001] [2] = OFF

DIP switch 3 = OFF

[001] [2] = ON

DIP switch 3 = ON

[001] [3] = OFF

Enabled when DIP switch 3 = ON

[001] [3] = ON

[001] [5] = OFF

N/A

[001] [5] = ON

N/A

[002] 001-010

Trimpot 0-10

Manual Settings