Creek Company ODC XR 12 Manuale di istruzioni per il montaggio - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Barca Creek Company ODC XR 12. Creek Company ODC XR 12 6.

Your ODC Outdoor Discovery Craft is designed to give you many years of service.

IF YOU EVER HAVE ANY QUESTIONS OR PROBLEMS WITH YOUR ODC XR 12 PLEASE DO NOT

RETURN IT TO THE DEALER YOU BOUGHT IT FROM. PLEASE CONTACT THE CREEK COMPANY

DIRECTLY TOLL FREE AT 1-800-843-8454. WE ARE OPEN M-F 9AM-5PM MOUNTAIN TIME. OR CONTACT US

1. Always wear a US Coast Guard approved personal flotation device when in your ODC XR 12.

2. Never float alone.

3. Always check your ODC XR 12 air bladders, frame, oar components, and pontoon covers for possible damage

before you use your craft.

4. Never use your craft if you suspect the air bladders, frame, oar components, or pontoon covers has been damaged.

5. Never over inflate your ODC XR 12.

6. Never use your ODC XR 12 without the air chambers fully inflated.

1. If your pontoon bladder is losing air, please check that valve assembly and top valve cap are fully seated. Reseat valve

assembly and repeat pontoon inflation instructions.

2. Do not store your ODC XR 12 in direct sunlight.

3. If you are leaving your ODC XR 12out in the sun for any amount of time, be aware that the heat can increase the

pressure inside the pontoons to a dangerous level. Let some of the air out of the pontoons if the craft will be out of the water

in the sun for any length of time, or if it is stored in a vehicle, etc.

4. A gain in altitude will increase the pressure in the pontoons also. If you are taking your inflated ODC XR 12 from

a low elevation to a high elevation, be sure to let some of the air out of it.

5. For short term storage, we recommend you let some air out of your pontoons.

6. For long term storage, we recommend you make sure your ODC XR 12 is completely dry, deflated and stored out of

the sunlight in a cool dry area.

7. Repairing bladder, use enclosed patch kit. Fully deflate bladder. Remove safety split-ring from zipper pull and open

zipper in pontoon cover. Remove bladder from inner liner. Identify puncture. Clean and dry area around puncture.

Apply glue to puncture area and patch using applicator straw. Press patch over puncture area. Allow 24 hours to

dry before Inflation.

8. Note: Metal parts may rust and are not covered under warranty.

Accessories are available for your ODC XR 12. Ask for them where you bought your ODC XR 12,

All Creek Company products are guaranteed against defects in material and workmanship for the life of the product to

the original owner. This does not cover damage due to misuse or normal wear and tear.

ODC XR 12™

O O U U T T D D O O O O R R D D I I S S C C O O V V E E R R Y Y C C R R A A F F T T

Please follow inflation instructions and warnings carefully.

HIN

IS LOCATED ON SQUARE TUBING OF SEAT SUPPORT FRAME MEMBER

AND ON RIGHT MAIN FRAME MEMBER (SEE FIGURE 4)

Please read and follow carefully.

CARE AND MAINTENANCE:

or visit the Creek Company Store at www.creekcompany.com

The Creek Company Ltd. , PO Box 773892, Steamboat Springs, CO 80477

970-879-5221 • fax 970-879-7577 • email: [email protected]

Specifications and other details subject to change without notice.

Warning:

T T M