Ayra TDC Flower Power Manuale d'uso - Pagina 7
Sfoglia online o scarica il pdf Manuale d'uso per Apparecchio di illuminazione Ayra TDC Flower Power. Ayra TDC Flower Power 16. Led flower light effect
Stampa la pagina
To activate the device, plug it into a mains socket. Once it's connected to an active power source, it will turn
on automatically.
The device cannot be operated while it is still starting up and the Menu screen displays 'rST'. Once the
device has fully started up, it will automatically jump to the last mode and setting. Operation modes and other
settings shown on the display can now be adjusted or changed via the menu buttons.
If a DMX signal is detected, the device shall automatically switch to DMX mode and the DMX address that
was last used. For a new device, this is usually DMX address 001. The DMX address can of course be
changed via the display and menu buttons.
The functions, modes and settings can be changed by using the display and menu buttons. Push 'Enter' to
select a function or to confirm a change. Push 'Up' and 'Down' to change any values and push the 'Menu'
button to return to the main menu. A few seconds after confirming a setting by pressing 'Enter', the device
shall automatically return to the main menu and perform the set actions. This can be sped up by holding the
'Menu' button down for 2 seconds after confirming a setting by pressing 'Enter'. This is usually done after
adjusting the working mode or DMX address.
The Menu includes the following options and fuctions:
Display
Mode
ADDR / A001
DMX Address Configuration
CHND
Channel Mode Selection
SLND
Slave Mode
SHND
Select Built-in Shows
SOUND
Sound-Controlled Mode
SENS
Sound Sensitivity
DNST
DMX Signal Loss Mode Selection
LED
LED Display Off / On when not in
use
DISP
Display Inversion
REST
Reset Function
TEMP
Temperature Display
F HS
Duration of use
VER
Firmware Version
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials: 07-10-2019 RV
Operation and Mounting
Function
Address A001 ... A512
10CH
Master
Slave
Show mode AU0-8
Mode: ON / OFF
0 - 100: Sensitivity in %
NAST - Master-modus
LAST – Last signal received
BLND – Blackout mode
ON/OFF
Display Invert, disp - dslp
Restart the device
Displayed in Degrees Celsius
0000 – 9999 Hours of use
Displays current version of firmware installed.
This cannot be adjusted or changed
Revision date and author's initials: -