FIALA MOTORS FM 170 B2-FS Manuale - Pagina 6

Sfoglia online o scarica il pdf Manuale per Motore FIALA MOTORS FM 170 B2-FS. FIALA MOTORS FM 170 B2-FS 8.

Manual for motor FM 170 B2 - FS ( Date of publication 06/2016)

8. Install the motor inside the model

When thinking about the placement of the engine into the model, keep in mind that it is absolutely

necessary to ensure proper cooling. Use the 4 screws to attach the motor to the motor mount.

Engine mount directly without dampers. Use self-locking nuts and / or thread adhesive of medium

strength. For our engines can not use a muffler designed for two-stroke motors! Our recommended

muffler, its size and weight, go to www.fialaprop.com, or to inform on e-mail:

9. Motor maintenance

The motor is designed and constructed to require as little maintenance. Valve clearance is checked

every 3 hours of operation of the motor and yet the valves lubricated. At the same time checks the

condition of the spark plugs and ignition battery status.

9.1. Adjusting valve clearances – only on cold motor!

The correct valve clearance is cold engine 0.1 mm. Is set with the gauge attached and keys.

1. Remove the valve cap

2. Turn propeller to remain both valves as well ajar

3. Then turn the propeller in the same direction by one revolution

4. Adjust the valve clearance - see the following text

5. Lubricate the rocker - see section 9.2

6. Replace the valve cover

Setting procedure: loosen the nut, place the gauge between the rod and rocker arm and adjust

gradual screwing clearance so that the gauge was sliding grip. Then tighten the nut again. After

tightening recheck valve clearance. More tells you the following three photos. A system of

adjustment is a classic - cut right valve adjusts the left and vice versa.

FIALA PROP s.r.o, Vysoká 56, 75641 LEŠNÁ , Czech Republic , e-mail: [email protected]

www.fialaprop.com

Page 6