FIAMA EP7 Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Strumenti di misura FIAMA EP7. FIAMA EP7 8. Battery-powered electronic position indicator

Stampa la pagina
FIAMA EP7 Manuale d'uso
EP7
Programming
To access programming of the parameters, keep
Now press 2 times
ENTER
blinking: with
(digit increase) and
confirm with
/
ENTER
programming.
The various parameters can be scrolled with
* When the Offset, Preset, and Origin Change functions are set, also the
parameters will appear (see further below).
To modify the selected parameter press two times
value). With
and
To set a negative number, press
and after press
so that the minus sign will appear.
To exit programming press
Value to be displayed after one complete rotation of the hollow shaft:
This parameter, together with the following one, defines the value which is displayed after one
rotation of the hollow shaft. The allowable range is from 0,0001 to 99999.
The decimal place is set after programming the last digit on the left: after pressing
place will blink and with
Number of decimal places:
It is the number of decimal places to visualize on the display, allowed range from 0 to 4.
Example 1: if each rotation of the hollow shaft will cause a displacement of 50, set
=0.
Example 2: if each rotation of the hollow shaft will cause a displacement of 12,345 and the desired
output on the display is 12.3, set
Button activation mode:
This parameter programs the button functions.
The value is a number with 3 digits, each corresponding to a button: the digit on the right sets the
/
button, the digit in the middle sets
ENTER
RESET
The possible values are in the following table:
VALUE
0
1
2
3
4
5
6
7
8
* Delayed means that to activate the function (reset or preset), it is necessary to keep
/
pressed for approximately 3 s.
ENTER
RESET
Date: 13/01/16
/
and 3 zeroes will appear. The first digit on the right will be
RESET
(digit selection) insert the pass code which is 273 and
. In case of incorrect insertion of the password, the unit exits
RESET
value to be displayed after one complete rotation of the shaft
number of decimal places
button activation mode *
counting direction
set the desired value and confirm with
until the last digit on the left blinks then press
.
it can be moved to the desired position. Confirm with
=12.345 and
Not active
mm/inch conversion
Not active
Not active
Not active
Not active
Not active
Not active
Not active
File: EP7_ing_rev1.7.doc
pressed until
and in order of appearance they are:
/
(the first time displays only the
ENTER
RESET
/
ENTER
RESET
=1.
while the last digit on the left sets
Not active
abs/rel
measurement
Not active
Not active
Not active
Not active
Not active
Not active
Not active
Electronic position indicator
appears on the display.
,
,
,
.
once again
, the decimal
/
.
ENTER
RESET
=50 and
.
/
ENTER
RESET
Not active
Reset
Preset
Fast Preset
Change of origin
0,1,2
Offset
Fast Offset
Delayed reset *
(after 3s)
Delayed preset *
(after 3s)
Page: 4/8
,