Digilock numeris aspire Manuale del prodotto - Pagina 5
Sfoglia online o scarica il pdf Manuale del prodotto per Tastiera Digilock numeris aspire. Digilock numeris aspire 11. Touch rfid latch mechanism
Anche per Digilock numeris aspire: Manuale di installazione (16 pagine), Manuale del prodotto (6 pagine)
Stampa la pagina
Programming Instructions - In Assigned Use Functionality
Express Register User Credentials and Manager Keys
Make sure the lock is set for assigned use functionality (a green LED will flash when
multiple locks to operate with the same user credentials and Manager Keys.
1
Go to a lock already
programmed to operate with
the user credentials and
Manager Keys.
Press
= ` 66 `
LED will turn on.
*The Programming Key will continue to function in express registration mode until it is used to operate a lock.
Remove User Credentials
Make sure the lock is in assigned use functionality (a green LED will flash when
user credentials from operating a lock.
1
Collect all remaining and replacement user credentials
(User Codes and User Keys).
3
Insert the Manager Key again.
Three sets of two-tone beeps will be heard and the LED will turn
off. All previously assigned user credentials will be removed.
5
2
Insert the Programming Key.
A two-tone beep will be heard
and the LED will turn off.
. The
Product Guide
Standard Keypad
Bolt Mechanism
is pressed). The Programming Key can quickly program
=
3
Insert the Programming Key to
program each lock to operate
with the same user credentials
and Manager Keys.
Two sets of two-tone beeps will
be heard and the LED will flash
twice to indicate successful
programming.
is pressed). The locks must be reprogrammed to remove
=
2a
Press
= ` 5 5 `
The LED will turn on.
Insert a valid Manager Key.
A two-tone beep will be heard.
4
Follow Assign User Credentials instructions to assign the remaining
and replacement user credentials to the locks.
Shared & Assigned Use Functionality
4a
4b
End express registration mode.*
Go to any programmed lock.
Press
then insert the
= `
Programming Key.
Press
then insert the
= `
Programming Key again to
return the bolt to the original
position.
2b
.