Accusound ES40 Eclipse Series Manuale di istruzioni - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per Sistema Home Theatre Accusound ES40 Eclipse Series. Accusound ES40 Eclipse Series 4. Eclipse series home theatre system

Stampa la pagina

Speaker Terminals

Speaker wire can be inserted into the hole in the shaft of the centre and rear speaker's connection

terminals. Simply strip away approximately 10mm of the wire jacket, unscrew the connection terminal,

insert the wire through the hole in the shaft, and then tighten the terminal. Make sure all connections are

tight and no stray wire strands touch the opposite terminal. If a wire is loose, it can cause a crackling or

static type sound that can be heard through the speaker. If it comes loose, it can cause your receiver to

short circuit.

Front Speaker Connections

Wireless Transmitter Rear Panel

On the back of the 2 front speakers are 2 push in connection terminals. Red is positive (+) and Black is

negative (-). From your receiver's positive terminal connect the speaker wire to the (+) mark which is the

Red terminal on the speaker. Push the terminal in and insert the wire into the hole. Release the terminal

and the wire is connected. Connect the negative (-) wire to the Black terminal.

Centre Speaker / Wireless Transmitter

On the back of the transmitter there are 3 sets of speaker connections. Look at the wiring diagram on

page 3 for the connections. Connect speaker wire from your receiver's surround speaker terminals and

the centre speaker terminals to the left and right inputs and centre input on the transmitter. Please ensure

that the left surround output goes to the left surround input and the same for the right side. Do the same

with the centre speaker connection. . Make sure the polarity + to + and - to - is correct. These are screw

in terminals.

Power Switch

There is a 2 pin power socket on the right side of the centre/transmitter. Plug the power cable supplied in.

There is a power switch. Turn this on and leave it on as this goes to standby when the system is not

being used.

Front Speaker Terminals

Wireless Transmitter Controls

There is 1 button on the rear panel of the transmitter. This is a channel button for the surrounds. This

controls the frequency if you have interference with cordless hand phones, wireless internet or microwave

ovens.

Wireless Surround Speaker Connection

Plug the surround speakers into the power. Turn on the rear power switch and set the volume control at

zero. This can be adjusted to fine tune later. When you are not using the system for a long period or go

on holidays, turn the power switch to off on the back of each surround speaker.

Wireless Transmitter Surround set up

To get connected turn your receiver on and have a movie or music playing. If you have a setting called All

Channel on your receiver, use this for the set up as it will give you sound in all the speakers. If you play a

5.1 movie you may not get sound out of the wireless surround speakers unless the movie is producing

sound from the surround speakers.

Channel Change

There are 8 channels available. If you get interference, press the channel button once, this takes you to

the next channel. Press the channel button once and listen to see if the interference has gone. Keep

Centre/Transmittor Speaker Terminals

going until all interference has been eliminated. Play the system and listen to see if all the speakers are

balanced.

This again is a once off setting unless you have a blackout. If the power has been

disconnected you have to reset the channel.

Wireless Receiver