Cisco 1503 Manuale del software - Pagina 2

Sfoglia online o scarica il pdf Manuale del software per Interruttore Cisco 1503. Cisco 1503 49. Cisco systems switch user manual

Preparing for Configuration

Connection Using Telnet

If the hub is correctly connected to a network, you can access the hub by using Telnet from

anywhere on that network and can use the configuration program to communicate with the

hub. Before making a Telnet connection to the hub, you must configure the hub with a valid

IP address, subnet mask, and default gateway using the configuration program.

Configuration Using a PC

If you are configuring the hub with a PC (not a dumb terminal), you need a type of

communication software called terminal emulation software to send commands to the hub.

Table 3-1

PC Operating System

Windows 3.x or

Windows NT 3.5x

Windows 95 or

Windows NT 4.x

Macintosh

Terminal emulation software has changeable settings. To enable your PC to communicate

to the hub, specify the port used by your PC (for example, COM 1), and then configure the

software settings to the following:

•

Terminal emulation type: ANSI

•

Baud: 9600

•

Data bit: 8

•

Parity: None

•

Stop bits: 1

•

Flow control: None

3-2

Cisco Micro Hub User Guide

Common Terminal Emulation Software Programs

Software

Terminal (included with the Windows software)

HyperTerm (included with the Windows software)

ProComm, VersaTerm, ZTerm (supplied separately)