Cisco 2950 - Catalyst Switch Manuale - Pagina 13

Sfoglia online o scarica il pdf Manuale per Interruttore Cisco 2950 - Catalyst Switch. Cisco 2950 - Catalyst Switch 19. Long-reach ethernet switches
Anche per Cisco 2950 - Catalyst Switch: Manuale di soluzione (17 pagine), Bollettino dei prodotti (3 pagine), Bollettino di assistenza prodotti (5 pagine), Manuale di migrazione (25 pagine), Bollettino di assistenza prodotti (6 pagine), Manuale introduttivo (29 pagine), Scheda tecnica (20 pagine)

Stampa la pagina
Cisco 2950 - Catalyst Switch Manuale
Cisco - Connecting a Terminal to the Console Port on Catalyst Switches
Switch
RJ45-to-RJ45
Console
Rollover Cable
(DTE)
RJ45
Signal
Pin
RTS
1¹
DTR
2
TxD
3
GND
4
GND
5
TxD
6
DSR
7
CTS
8¹
¹Pin 1 is connected internally to Pin 8.

Configuring a Terminal for Attachment to the Console or RSFC Port

Note: The console port is an asynchronous (Async) serial port; any device connected to this port must be
capable of asynchronous transmission.
Before connecting the console port, check the terminal documentation to determine the baud rate. The
baud rate of the terminal must match the default baud rate (9600 baud) of the console port. Set up the
terminal as follows:
9600 baud
8 data bits
No parity
1 stop bit
Connecting a Terminal to the Catalyst 4000
Supervisor Engine I Console Port
The console port, shown in the figure below, is a data communications equipment (DCE) DB-25
receptacle that supports a DCE EIA/TIA-232 interface. EIA/TIA-232 supports unbalanced circuits at
signal speeds up to 64 kbps.
Figure: DCE DB-25 Connector
http://www.cisco.com/warp/public/473/9.html (13 of 19) [9/4/2003 12:36:03 PM]
RJ45-to-DB25
Adapter
RJ45
DB25 Pin
Pin
8
5
7
6
6
3
5
7
4
7
3
2
2
20
1
4
Terminal
(DTE)
Signal
CTS
DSR
RxD
GND
GND
TxD
DTR
RTS