Cisco 2970 - Catalyst Switch Manuale - Pagina 9

Sfoglia online o scarica il pdf Manuale per Interruttore Cisco 2970 - Catalyst Switch. Cisco 2970 - Catalyst Switch 19. Ios software release 12.1(14)ea1
Anche per Cisco 2970 - Catalyst Switch: Bollettino dei prodotti (5 pagine), Bollettino di assistenza prodotti (6 pagine), Bollettino di assistenza prodotti (6 pagine)

Cisco - Connecting a Terminal to the Console Port on Catalyst Switches

Switch Console (DCE)

2 Rxd

3 Txd

4 RTS

5 CTS

6 DSR

7 GND

8 DCD

20 DTR

Configuring a Terminal for Attachment to the Console Port

Note: The console port is an asynchronous serial port; any device connected to this port must be capable

of asynchronous transmission.

Before connecting the console port, check the terminal documentation to determine the baud rate. The

baud rate of the terminal must match the default baud rate (9600 baud) of the console port. Set up the

terminal as follows:

9600 baud

8 data bits

No parity

1 stop bit

Connecting a Terminal to the Catalyst 5000

Supervisor Engine III Console Port

The port is located on the Supervisor Engine front panel and is labeled "CONSOLE," as shown above.

The port is an EIA/TIA-232 asynchronous, serial, full-featured data terminal equipment (DTE)

connection with hardware flow control and an RJ-45 connector. Use a straight-through cable to connect

the switch to a Data Terminal Equipment (DTE) device, such as a terminal or PC.

Note: If you need a replacement console port accessory kit for your Supervisor Engine III, the part

http://www.cisco.com/warp/public/473/9.html (9 of 19) [9/4/2003 12:36:03 PM]

Terminal (DTE)

3 TxD

2 RxD

7 RTS

8 CTS

6 DSR

5 GND

1 DCD

4 DTR