Cisco 3020 - Cisco Catalyst Blade Switch Manuale di installazione - Pagina 14

Sfoglia online o scarica il pdf Manuale di installazione per Interruttore Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 21. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Anche per Cisco 3020 - Cisco Catalyst Blade Switch: Manuale introduttivo (37 pagine), Manuale introduttivo (31 pagine), Specifiche rapide (12 pagine), Nota di rilascio (41 pagine), Nota di rilascio (27 pagine), Nota di rilascio (23 pagine), Nota di rilascio (21 pagine)

Stampa la pagina

Cisco 3020 - Cisco Catalyst Blade Switch Manuale di installazione

Running Express Setup

The Express Setup page appears. (See

Figure 2-9

Step 9

Go to

using the Express Setup screen of the Device Manager.

Completing the Express Setup Fields

Follow these steps to finish setting up the switch module:

Enter this information in the Network Settings fields:

Step 1

(Optional) You can enter the Optional Settings information now or enter it later by using the device

Step 2

manager interface:

Cisco Catalyst Blade Switch 3020 for HP Hardware Installation Guide

2-14

Express Setup Page

"Completing the Express Setup Fields" section on page 2-14

In the Management Interface (VLAN ID) field, the default is 1. Enter a new VLAN ID only

–

if you want to change the management interface through which you manage the switch module

and to which you assign IP information. The VLAN ID range is 1 to 1001.

In the IP Address field, enter the IP address of the switch module. In the IP Subnet Mask field,

–

click the drop-down arrow, and select an IP Subnet Mask.

–

In the Default Gateway field, enter the IP address for the default gateway (router).

Enter your password in the Switch Password field. The password can be from 1 to 25

–

alphanumeric characters, can start with a number, is case sensitive, allows embedded spaces,

but does not allow spaces at the beginning or end. In the Confirm Switch Password field, enter

your password again.

In the Host Name field, enter a name for the switch module. The host name is limited to

–

31 characters; embedded spaces are not allowed.

In the System Contact field, enter the name of the person who is responsible for the switch

–

module. In the System Location field, enter the wiring closet, floor, or building where the

switch module is located.

In the Telnet Access field, click Enable if you are going to use Telnet to manage the switch

–

module by using the CLI. If you enable Telnet access, you must enter a Telnet password.

Figure

2-9.)

Chapter 2

Switch Installation

to finish setting up the switch module

OL-8914-02