Fiap Aqua Active Eco Manuale - Pagina 3

Sfoglia online o scarica il pdf Manuale per Pompe per laghetti Fiap Aqua Active Eco. Fiap Aqua Active Eco 18.

Stampa la pagina

FIAP Aqua Active Eco

Entsorgung

Das Gerät ist gemäß den nationalen gesetzlichen Bestimmungen zu entsorgen. Fragen Sie Ihren

Fachhändler.

Störung

Ursache

Das Gerät saugt nicht

Netzspannung fehlt

Laufrad blockiert/läuft trocken

Wasserlauf ungenügend

Filterschale verschmutzt

Schlauch verstopft

Schlauch geknickt

Zu hohe Verluste in den

Schlauchleitungen

Gerät schaltet nach kurzer

Filterschale verstopft

Laufzeit ab

Läuft trocken

Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045

FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen

Tel: 09628 9213 0; Fax: 09628 9213 30;

Abhilfe

Netzspannung überprüfen

Reinigen/Zuleitungen

kontrollieren

Reinigen

Reinigen, ev. ersetzen

Schlauch prüfen, ev. ersetzen

Schlauchlänge auf nötiges

Minimum reduzieren

Reinigen

Zuleitung kontrollieren

www.fiap.com

FIAP Aqua Active Eco

Information about this operating manual

Please read the operating instructions and familiarise yourself with the unit prior to using it for the first

time. Adhere to the safety information for the correct and safe use of the unit.

Intended use

FIAP Aqua Active Eco 4.500 – 20.000, in the following text termed unit, has been exclusively produced

for pumping normal pond water for filters, water falls and water courses and has to be used at a water

temperature of between 4°C and +35°C. The unit performance can only be controlled by an FIAP

Controll Active. The unit is frost proof.

The unit is suitable for use for swimming and bathing ponds in accordance with the national installer

regulations.

Use other than that intended

Danger to persons can emanate from this unit if it is not used in accordance with the intended use and

in the case of misuse. If used for purposes other than that intended, our warranty and operating permit

will become null and void.

CE Manufacturer's Declaration

We declare conformity in the sense of the EC directive, EMC directive (89/336/EEC) as well as the low

voltage directive (73/23/EEC). The following harmonised standards apply:

EN 60335-1, EN 60335-2-41, EN 55014-2, EN 61000-3-2, EN 61000-3-3

Safety information

For safety reasons, children and young persons under 16 years of age as well as persons who

cannot recognise possible danger or who are not familiar with these operating instructions, are

not permitted to use the unit!

Please keep these operating instructions in a safe place! Also hand over the operating instructions

when passing the unit on to a new owner. Ensure that all work with this unit is only carried out in

accordance with these instructions.

The combination of water and electricity can lead to danger to life and limb, if the unit is incorrectly

connected or misused. Only operate the unit if no persons are in the water! Prior to reaching into the

water, always disconnect the power supply to all units used in the water. Compare the electrical values

of the power supply with those on the type plate on the packaging or on the unit itself. Ensure that the

unit is fused for a rated residual current of max. 30 mA via a residual current-operating system. Only

operate the unit when plugged into a correctly fitted socket. Keep the power plug and all connection

points dry! Protect the connection cable when burying to avoid damage. Only use cables, equipment,

adapters, extension or connection cables with an earthed contact and approved for outside use. Do not

carry or pull the unit by the connection cable! Never operate the unit if the cable or housing are

defective! The power connection cable of this unit cannot be replaced. If the cable is damaged, the

entire unit has to be disposed of. Electrical installations at garden ponds must meet the international

and national regulations valid for installers. Never open the unit housing or its attendant components,

unless this is explicitly mentioned in the operating instructions. Never carry out technical changes to

the unit. Only use original spare parts and accessories. Only allow authorised customer service outlets

to perform repairs. Never run the unit without water! Never use the pump for fluids other than water!

For your own safety, consult a qualified electrician if you have questions or encounter problems!

Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045

FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen

Tel: 09628 9213 0; Fax: 09628 9213 30;