Cisco 3750 - Catalyst EMI Switch Manuale introduttivo - Pagina 21

Sfoglia online o scarica il pdf Manuale introduttivo per Interruttore Cisco 3750 - Catalyst EMI Switch. Cisco 3750 - Catalyst EMI Switch 27. Catalyst 3750 series switches
Anche per Cisco 3750 - Catalyst EMI Switch: Scheda tecnica (18 pagine), Istruzioni per l'installazione (47 pagine), Faq (10 pagine), Bollettino dei prodotti (5 pagine), Bollettino di assistenza prodotti (6 pagine), Panoramica del prodotto (25 pagine), Descrizione (1 pagine), Scheda tecnica (23 pagine), Bollettino di assistenza prodotti (6 pagine), Scheda tecnica (23 pagine), Manuale introduttivo (33 pagine)

Install the XENPAK Module and Connect to the Ports

Follow these steps to install

Catalyst 3750G-16TD switch:

Remove the two Phillips-head

Step 1

retaining screws from the XENPAK

module slot cover, and store them for

later use. Remove the cover.

Align the XENPAK module with the

Step 2

guide rails inside the module slot,

and slide the module into the slot

until the XENPAK faceplate is flush

with the switch faceplate.

Secure the XENPAK module in place by tightening the two captive installation

Step 3

screws. Do not overtighten the screws.

Remove the rubber plugs from the XENPAK module ports and fiber-optic cable, and

Step 4

store them for future use.

Align the cable SC connector with

Step 5

the XENPAK module connector, so

that transmit (TX) meets receive

(RX), and RX meets TX.

See the "Verify Port Connectivity" section on page 20 for instructions on how to verify that the

XENPAK module ports have established a link to the external device.

a XENPAK module into the XENPAK module slot on the front panel of the

Rubber

XENPAK

plug

module

C at al ys t 37

se rie s

C at al ys t 37

se rie s

C a ta ly st 3

7 5 0

se ri es

T X

R X

XENPAK

module