Cisco 500 Series Manuale di avvio rapido - Pagina 6

Sfoglia online o scarica il pdf Manuale di avvio rapido per Interruttore Cisco 500 Series. Cisco 500 Series 21. Stackable managed switches
Anche per Cisco 500 Series: Manuale di informazioni sulla sicurezza (42 pagine), Manuale (4 pagine), Quide di avvio rapido (13 pagine), Scheda tecnica (5 pagine), Manuale d'uso (4 pagine), Manuale d'uso (6 pagine), Manuale d'uso (46 pagine), Manuale (40 pagine), Manuale di amministrazione (48 pagine), Manuale (24 pagine), Risoluzione dei problemi e manutenzione (15 pagine), Manuale di riferimento rapido (7 pagine), Manuale di avvio rapido (25 pagine)

Stampa la pagina
Cisco 500 Series Manuale di avvio rapido
Details on how to change the IP address on your computer
N
OTE
depend upon the type of architecture and operating system you are
using. Use the computer Help and Support functionality to search for "IP
Addressing."
Open a Web browser window. If you are prompted to install an
S
3
TEP
Active-X plug-in when connecting to the device, follow the
prompts to accept the plug-in.
Enter the switch IP address in the address bar and press Enter. For
S
4
TEP
example, http://192.168.1.254.
The Switch Login Page displays.
Enter the default login information:
S
5
TEP
•
Username is cisco
•
Default password is cisco (passwords are case sensitive)
If this is the first time that you have logged on with the default
S
6
TEP
username and password, the
rules for constructing a new login and password are displayed on
the page. Enter a new administrator password and click Apply.
Make sure that any configuration changes made are saved to
C
AUTION
the Startup configuration before exiting from the web-based
interface by clicking on the Save icon. Exiting before you
save your configuration will result in all current changes
being lost the next time the switch is rebooted.
The Getting Started window displays. You are now ready to configure the
switch. Refer to the
Administration Guide
Use the console port
To configure the switch by using the console port:
Connect a computer to the switch console port by using the
S
1
TEP
provided serial cable.
Start a terminal application such as HyperTerminal on the
S
2
TEP
computer.
Configure the utility with the following parameters:
S
3
TEP
•
115200 bits per second (with release 1.2.7 of the firmware,
autobaud detection is enabled by default, so the switch should
detect the speed after you press Enter).
6
Cisco 500 Series Stackable Managed Switch
for further information.
Change Password Page
500 Series Stackable Managed Switches
opens. The