Crest Audio BRBMON1 Manuale di avvio rapido - Pagina 2

Sfoglia online o scarica il pdf Manuale di avvio rapido per Cremagliere e cavalletti Crest Audio BRBMON1. Crest Audio BRBMON1 2. Monitor mount 32"max

Step 1: Install Onto Desk or Table

1. Attach arm (D) to plate (C) using bolts (H) and cover bolts with cap (G).

2. Tighten with key (K).

3. Alternatively remove control wheel from part (C) and thread through plate (I) and through hole in the desk. (Desk will need

to have a hole or one will need to be drilled for this method).

Step 2: Attach Mounting Arm

Attached arm as shown, tightening with Key (L).

Step 3: Attach Mounting Plate to Monitor

1. Using a second person for assistance, lay your Monitor face down on something soft so as not to scratch the screen.

2. Check the back of your Monitor to find the appropriate mounting pattern.

3. Sort through the provided bolts (M-A to M-D) until you find the correct size that easily fits into the back of your Monitor

and fits snugly (the bolt must turn at least 3 full turns, do not tighten). If you feel resistance stop immediately and select a

smaller bolt.

Once you have selected the correct bolt size, use the washer (M-E ). If no bolts fit you will need to go to your local

hardware supplier to find the correct bolt and washer sizes.

4. Gently put your Monitor plate (A) on the back of the Monitor so that the mounting holes are showing through the holes of

the mounting plate.

If the back of your Monitor is curved or recessed you will also need to use a spacer (M-F) depending upon the amount of

space you are trying to clear. If using a spacer you will also need to use longer screws. Remember that the bolt needs to

turn at least 3 full turns.

5. Using the correct mounting bolt size and length, insert these through the corresponding hole on the washer (M-E) to attach

mounting arms to the rear of the TV. To avoid damaging TV, do not over tighten bolts.

The Crest Company is not responsible for any damage caused by screwing the bolt too far into the back of the TV.

Step 4: Attach Monitor onto Mounting Arm

1. Using a second person for assistance, carefully lift the Monitor and attach Monitor to the mounting arm.

2. Slowly lower the bottom of the Monitor until the bottom of the mounting plate locks into the mounting arm.

3. Tighten bolt (J) at the top of the mounting plate to make sure the Monitor is secure.

Check your Monitor is secure and safe to use at regular intervals (at least every three months).

4. Tighten where required with Key (L) and (K).

The Crest Company is not responsible for any damage caused by screwing the bolt too far into the back of the Monitor.