Cisco 9134 - MDS Multilayer Fabric Switch Manuale di configurazione - Pagina 24

Sfoglia online o scarica il pdf Manuale di configurazione per Interruttore Cisco 9134 - MDS Multilayer Fabric Switch. Cisco 9134 - MDS Multilayer Fabric Switch 49. Mds 9000 series
Anche per Cisco 9134 - MDS Multilayer Fabric Switch: Specifiche tecniche (3 pagine), Nota di rilascio (48 pagine), Nota di rilascio (44 pagine), Nota di rilascio (22 pagine), Nota di rilascio (3 pagine), Nota di rilascio (40 pagine), Note di rilascio (10 pagine), Manuale (16 pagine), Manuale di installazione dell'hardware (36 pagine)

Figure 13 Active Sessions tab—Connected status

Installing the EVA CCL Drivers on the iSCSI initiator

At this point, the Windows New Hardware Found Wizard may appear, because the EVA (Command

Console LUN) CCL was discovered by the operating system. This Wizard requires the following two ﬁles:

•

The EVA CCL driver—HsgCCL.inf

•

The Windows security ﬁle—HsgCCL.cat

These ﬁles are located on the Windows EVA Platform Kit CD. The Windows EVA Platform Kit can also

be downloaded from the HP web site:

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?locBasepartNum=co-

17666-2

CAUTION:

Do not install the Windows EVA Platform Kit on the iSCSI server. Only extract the necessary ﬁles to

complete the EVA CCL Driver installation.

The following procedure is the same if you are loading the ﬁles from the CD or downloading from the

web site. To extract the HsgCCL.inf, and HsgCCL.cat ﬁles:

Copy the HP Package ﬁle \Setups\cp003937.exe to a temporary location on the iSCSI server.

Double click cp003937.exe to start the HP Package Setup.

The HP Package Setup Window appears.

Click Extract.

Select or create a temporary folder, and then click OK.

All ﬁles in the package are copied to the speciﬁed folder.

Resume the Windows Found New Hardware Wizard.

When prompted, point it to the temporary folder where the driver and security ﬁle reside.

Follow the instructions provided by the wizard.