Cisco 9134 - MDS Multilayer Fabric Switch Manuale di configurazione - Pagina 43

Sfoglia online o scarica il pdf Manuale di configurazione per Interruttore Cisco 9134 - MDS Multilayer Fabric Switch. Cisco 9134 - MDS Multilayer Fabric Switch 49. Mds 9000 series
Anche per Cisco 9134 - MDS Multilayer Fabric Switch: Specifiche tecniche (3 pagine), Nota di rilascio (48 pagine), Nota di rilascio (44 pagine), Nota di rilascio (22 pagine), Nota di rilascio (3 pagine), Nota di rilascio (40 pagine), Note di rilascio (10 pagine), Manuale (16 pagine), Manuale di installazione dell'hardware (36 pagine)

Setup

If you are not using DHCP, follow the setup instructions in the Cisco Gigabit Ethernet Switch Module for

HP p-Class BladeSystem Software Conﬁguration Guide, to assign the CGESM an IP address. Use a web

browser to access the conﬁguration management and operation features at http://10.10.10.168:80,

where 80 is the default port number.. Use the web interface to disable the cross connection (XConnects)

(ports 17 and 18) and to ensure all ports are in the same VLAN.

Disabling the cross connection ports

With XConnects between Interconnect A and Interconnect B, the multi-path solution may use loops

established at the interconnect switching level. To avoid this, disable the XConnects. Each interconnect

model has different XConnect ports. Some interconnects don't enable these ports by default. The following

procedure assumes the use of CGESM. See the interconnect documentation for more information.

Click the Conﬁguration link in the left frame of the web

page.(Figure

40).

C-Series iSCSI