Cisco BTS 10200 Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Interruttore Cisco BTS 10200. Cisco BTS 10200 35. Softswitch

Connect External Network Uplink Cables to Ethernet Switches

Follow these steps to connect the external network uplink cables to the Ethernet switches:

Step 1

Refer to

Switch A and which is Ethernet Switch B.

Step 2

If your local network documentation calls for gigabit Ethernet, contact Cisco TAC for assistance.

Step 3

If your local network documentation calls for 100 Mb Ethernet, connect the applicable network uplink

cables as listed in

Step 4

After installing the uplink cables, record the necessary information on a copy of

document according to local procedures.

Follow these steps to connect the SS7 signaling cables to the CA units of the

Cisco BTS 10200 Softswitch:

Refer to

Step 1

Connect T1 cables for SS7 signaling to the SPE0 and SPE1 connectors on CA A (see

Step 2

Note

Connect T1 cables for SS7 signaling to the SPE0 and SPE1 connectors on CA B.

Step 3

Route the other ends of these T1 cables as specified in local network documentation, and add (write in)

Step 4

this information on a copy of

OL-2906-01

C I S C O C O N F I D E N T I A L

Figure 1 on page 2

to identify which Cisco 2924M Ethernet Switch is designated Ethernet

Table

1. Ports #21 through 24 are available for this use.

Figure 1 on page 2

to identify which unit is CA A and which is CA B.

SPE2 and SPE3 are not used.

Table 1

Connect External Network Uplink Cables to Ethernet Switches

or similar document.

Table 1

or similar

Figure

6).