BYOC 10-band graphic equalizer Manuale di istruzioni - Pagina 11

Sfoglia online o scarica il pdf Manuale di istruzioni per Pedale musicale BYOC 10-band graphic equalizer. BYOC 10-band graphic equalizer 14.

Step 4: Install the circuit board so that the 3 screws fit into the 3 mounting holes in the circuit

board. CAREFULLY !!!!!!!!! slide the circuit board all the way down to the nylon spacers.

The slider knobs will probably not line up with their respective channels. You will need to use

some sort of probe-like tool like a very small screwdriver and insert it into the trouble

channels and very gently bend the entire slide to one side so that it is properly aligned with its

channel.

Even if the slider knob fit into its channel without any trouble, you should still go through all

of the sliders and center any that are not perfectly aligned.

Step 5:Add a toothed lock washer followed by a 4/40 hex nut to each of the 3 mounting

screws and tighten.

Step 6: Grab the LED leads that are sticking out of the component side of the PCB and

guide the LED into its hole. You only want the tip of the LED to stick out. You don't want it

to stick all the way out. Once you position the LED, solder it in place.