Cisco Business 250 Series Manuale di avvio rapido - Pagina 4

Sfoglia online o scarica il pdf Manuale di avvio rapido per Interruttore Cisco Business 250 Series. Cisco Business 250 Series 49. Smart switches
Anche per Cisco Business 250 Series: Manuale di avvio rapido (2 pagine), Manuali di avvio rapido (5 pagine), Conoscere (10 pagine), Manuale di avvio rapido (17 pagine), Conoscere (16 pagine), Manuale di avvio rapido (5 pagine)

To install the switch into a 19-inch standard chassis:

Place one of the supplied brackets on the side of the switch so that

TEP

the four holes of the brackets align to the screw holes, and then use

the four supplied screws to secure it.

Repeat the previous step to attach the other bracket to the opposite

TEP

side of the switch.

After the brackets are securely attached, the switch is now ready to

TEP

be installed into a standard 19-inch rack.

Wall Mounting

To mount the Cisco 250 Series Smart Switches to a wall:

Determine where you want to mount the device. Verify that the

TEP

surface is smooth, flat, dry, and sturdy.

Drill two pilot holes into the surface of the wall 94 mm apart.

TEP

Insert a screw into each hole, leaving a gap between the surface

TEP

and the base of the screw head.

Place the bottom of the switch over the screws and slide the

TEP

switch down until the screws fit snugly into the slots.

Insecure mounting may damage the device or cause injury.

ARNING

Cisco is not responsible for damages incurred by insecure wall

or ceiling mounting.

Cisco 250 Series Smart Switches