BYOC BA6110 Manuale di istruzioni - Pagina 9

Sfoglia online o scarica il pdf Manuale di istruzioni per Pedale musicale BYOC BA6110. BYOC BA6110 14.

Step12: DO NOT SOLDER the BA6110!!!! Only solder the SIP9 socket. And make sure

you solder it to the UNDERSIDE of the board. Install the Chip into the socket when you are

ready to test the pedal.(this is a pic of the 622 board, but the layouts are virtually identical)

DO NOT DO STEP 13 IF YOU HAVE A RECENT KIT!!!!!!!!!!!This jumper is needed on

the first run of PCBs to compensate for a very minor error. This error has been fixed on the

new PCBs. The older board that need the jumper will have two small cuts in the copper traces

on the underside of the board. The newer boards will not have any cuts on them and should

be marked V2 on the underside of the board.

Step 13: Make a jumper using left over clipping from one of the resistors to connect pin 4 of

the BA6110 to the open eyelet between the 33k resistor and 1k resistor.