Accustic Arts PLAYER I Manuale - Pagina 6

Sfoglia online o scarica il pdf Manuale per Lettore CD Accustic Arts PLAYER I. Accustic Arts PLAYER I 11.

Stampa la pagina

5 Operating the PLAYER II

5. 1 PLAYER II as a CD player

The PLAYER II is an audiophile 24 bit / 192 kHz upsampling CD player with a very precise CD drive designed

purely for audio playback. The device is compatible to CD, CD-R and CD-RW discs.

In order to use the PLAYER II as a CD player, it is only necessary to connect the AUDIO OUTPUT analog

outputs to the corresponding analog inputs on your integrated amplifier (e.g. ACCUSTIC ARTS

or preamplifier. We recommend use of high quality audio cables.

 Further information on CD player operation is available in Chapter

5. 2 PLAYER II as D/A converter

Four high quality digital inputs (coaxial and USB 32/384) additionally allow the PLAYER II to be a pure D/A

converter which can convert external digital signals into analog music signals. These inputs USB , IN-1 ,

IN-2 and IN-3 are selected by left rotary knob the on the front panel or with the AA system remote

control. When the device is used as a D/A converter, the CD section switches off and the selected input is

shown on the display.

In order to use the PLAYER II as a D/A converter, it is firstly necessary to connect both the AUDIO OUTPUT

analog outputs to the corresponding analog inputs on your integrated amplifier (e.g. ACCUSTIC ARTS

POWER I) or preamplifier. Then you can connect the selected digital input to the appropriate digital output

of the respective source device. We recommend use of high quality audio cables.

 Further information on D/A converter operation is available in Chapter

6 PLAYER I operation as a CD player

6. 1 Start-up and CD insertion

Switch on the device by pressing mains switch 2. The device switches automatically to CD mode. The laser

unit initialises itself for approximately 5 seconds and determines if a CD has been inserted or not. If no CD

has been inserted, the display changes to

If there is a CD in the device, after the initialisation of the laser the number of music tracks and total

playing time of the CD are displayed. The display then shows, for example, the following:

09 65 : 20

This display indicates the inserted CD has 9 music tracks with a total playing time of 65 minutes and 20

seconds.

If you wish to load a CD or exchange a CD which is already loaded, then first of all slowly push the cover 16

to the back and the display shows

Please note that the clamper has an integrated magnet and therefore sits rather firmly on the CD. After

removing the clamper you may now remove a CD. When removing the CD take care not to touch the laser

unit. Finger prints and dirt on the laser unit can disturb the scanning process.

Insert the desired CD and now place the CD clamper in the middle of the CD. Make sure that the clamper

locks correctly into position, otherwise playback is not possible. Close the cover 16 completely again. After

the closing process the laser initialises again, i.e. it scans the inserted CD and determines the number of

music tracks as well as the total time. If no CD is loaded or the CD clamper is not correctly fixed on to the

CD, the display shows

After the CD has been properly inserted the device is ready for operation and you can select the PLAY

FUNCTION with the right knob to play the CD.

Select the STOP to stop the CD.

The functions STOP and PLAY can also be operated from the remote control.

NO DISC

. Now remove the CD clamper by lifting it upwards.

0PEN

NO DISC

POWER I)