Cisco Catalyst 2960 Series Manuale introduttivo - Pagina 21

Sfoglia online o scarica il pdf Manuale introduttivo per Interruttore Cisco Catalyst 2960 Series. Cisco Catalyst 2960 Series 25. Compact switches
Anche per Cisco Catalyst 2960 Series: Scheda tecnica (16 pagine), Scheda tecnica (11 pagine), Scheda tecnica (9 pagine), Bollettino dei prodotti (3 pagine), Bollettino dei prodotti (5 pagine), Scheda tecnica (21 pagine), Specifiche tecniche (2 pagine), Opuscolo e specifiche (10 pagine), Scheda tecnica (15 pagine), Scheda tecnica (28 pagine), Opuscolo (17 pagine), Manuale di installazione (27 pagine)

Stampa la pagina
Cisco Catalyst 2960 Series Manuale introduttivo
Chapter 1
Getting Started Guide
Did you connect a crossover cable instead of
•
a straight-through Ethernet cable between a
switch port and the Ethernet port of the PC?
Did you connect the Ethernet cable to the
•
console port instead of to a 10/100 or
10/100/1000 Ethernet port on the switch?
Did you wait 30 seconds after connecting the
•
switch and the PC before entering the IP
address in your browser?
Did you enter the wrong address in the
•
browser, or is there an error message?

Resetting the Switch

Caution
OL-9368-03
This section describes how to reset the switch by rerunning Express Setup. These
are reasons why you might want to reset the switch:
You installed the switch in your network and cannot connect to it because you
•
assigned the wrong IP address.
You want to clear all configurations from the switch and assign a new IP
•
address.
You are trying to enter Express Setup mode, and the switch LEDs start
•
blinking when you press the Mode button (which means that the switch is
already configured with IP information).
Resetting the switch deletes the configuration and reboots the switch.
To reset the switch:
•
Press and hold the Mode button. The switch LEDs begin blinking after about
3 seconds. Continue holding down the Mode button. The LEDs stop blinking
after 7 more seconds, and then the switch reboots.
The switch now behaves like an unconfigured switch. You can enter the switch IP
information by using Express Setup as described in the
section on page
1-4.
If yes, connect a straight-through cable to an
Ethernet port on the switch and the PC. Wait 30
seconds before entering 10.0.0.1 in the browser.
If yes, disconnect from the console port. Connect
to an Ethernet port on the switch and the PC. Wait
30 seconds before entering 10.0.0.1 in the
browser.
If not, wait 30 seconds, re-enter 10.0.0.1 in the
browser, and press Enter.
If yes, re-enter 10.0.0.1 in the browser, and press
Enter.
Catalyst 2960 Switch Getting Started Guide
In Case of Difficulty
"Running Express Setup"
1-19