FIBARO SWIPE FGGC-001 Manuale operativo - Pagina 4

Sfoglia online o scarica il pdf Manuale operativo per Controllore FIBARO SWIPE FGGC-001. FIBARO SWIPE FGGC-001 13. Swipe gesture controller

#3: Basic activation

1. Remove the front magnetic cover.

2. unmount the Swipe from the back case by sliding the device

down.

3. Remove paper strip protecting the batteries.

4. Mount the Swipe back into the back case by sliding the device up.

5. The device will confirm powering up with an acoustic signal.

6. Place the front magnetic cover.

7. Place the Swipe onto its holder.

8. Place the Swipe within the direct range of your Z-Wave controller.

BASIC ACTIvATIOn

9. Plug the power source into the micro-uSB port if required.

10. Set the main controller in (security/non-security) add mode (see

the controller's manual).

11. Move and hold your hand close to the center of the pad.

12. If the device is battery powered, high pitched beep will signal

exiting the Standby Mode.

13. Loud sound sequence will confirm entering the menu, keep

holding your hand.

14. After hearing two short beeps (green indicator colour), withdraw

the hand and perform swiping up gesture to confirm selection

(two beeps will confirm validity).

15. Wait for the adding process to end.

16. Successful adding will be confirmed by the Z-Wave controller's

message and 3 short beeps (green visual indicator colour).

BASIC ACTIvATIOn