FIBER FOX Mini 6SI Manuale d'uso - Pagina 14
Sfoglia online o scarica il pdf Manuale d'uso per Hardware di rete FIBER FOX Mini 6SI. FIBER FOX Mini 6SI 16.
Stampa la paginaAppendix II
If error message is shown as below during the process, Please follow the instruction accordingly. If
the problem still remains, please contact us.
Error Message
Reason
L Fiber Place
Error
The fiber end-face is placed on the
electrode centerline, or beyond it
R Fiber Place
Error
The fiber is no set correctly at the
Propulsion
bottom of the V-groove, which
Motor Overrun
results in that the fiber offsets
beyond motor formation range
Propulsion
Motor might be damaged
Motor Trouble
Failed to Find
The fiber is not set correctly at the
The Fiber
bottom of the V-groove
End-face
No Arc
Arc Discharge does not occur
Discharge
The fiber is not set correctly at the
Motor Overrun
bottom of the V-groove
Cannot Find
The fiber is not set correctly at the
the Edge of The
bottom of the V-groove
Cladding
Find Wrong
There's dust on the fiber suface
Fiber Edges
Unidentified
Shock occurred to the splicer
Type of Fiber
during the splicing process
Solution
Press the "Reset" Button. Reload
the fibers, make sure fiber end
face between V-groove and the
centre position of electrodes
Press the "Reset" button and
then re-position the fiber at the
bottom of the V-groove
Consult your nearest sales agency
Press the "Reset" button and
then re-position the fiber correctly
at the bottom of the V-groove
Confirm the electrodes in proper
position; Replace electrodes
Press the "Reset" button and
then re-position the fiber at the
bottom of the V-groove
Press the "Reset" button and
then re-position the fiber at the
bottom of the V-groove
Re-prepare the fiber;
Clean the lens and protector mir-
ror and then redo "Dust Check"
Execute "Motor Calibration" If the
[problem stillexist, please contact
the sale agent
- 26 -
Unidentified
Shock occurred to the splicer
Type of Fibers
during the splicing process
Overlap too much
Contact of Fiber
End-faces
Motor is not calibrated
The fiber is misplaced
Focus Motor
There's dust of dirt on the fiber
Overrun
surface
There's dust of dirt on the fiber
surface
Fibers
The fibers of two sides are
Mismatch
different type
Bad fiber end-face
Large Cleave
Angle
[Cleave Limit] is set too low
[Core angle limit] is set too low
Large Core
Angle
Dust of dirt is on the V-groove or
hte clamp chip
Too large axial offset(>0.4um)w
Focus Error
The motor is not calibrated
Execute "Motor Clibration"
If the [problem still exist, please
contact the sale agent
Adjust overlap parameter
Calibrate and maintain the motor
Press the "Reset" vutton and then
reposition the fiber correctly
Prepare the fiber again
Execute the [Dust check] after the
lenses and LEDs are cleaned
It may resul tin large splice loss if
you continue to splice,
Please use the proper splice mode
corresponding to the fibers
check the condition of the fiber
cleaver, if the blade is worn,
rotate the blade to a new position
or change a new one, and then
re-prepare the fibers
Increase the [Cleave limit] to an
adequate limit(standard:3.0˚c)
Increase the [Core angle limit] to
an adequate limit (standard:1.0˚c)
Clean V-groove and clamp chip.
Prepare the fibers and re-load
them
Re-prepare the fibers
Execute [Motor clibration]
- 27 -