Fiber Instruments Sales CA6 Manuale di riferimento rapido - Pagina 2
Sfoglia online o scarica il pdf Manuale di riferimento rapido per Utensile elettrico Fiber Instruments Sales CA6. Fiber Instruments Sales CA6 2. Fusion splicer
Stampa la pagina1
Splice program setting
1. Tap the Splice program label
on the Settings panel.
* Setup and change the Heater program in the same procedures as described above.
2
Perform an arc test
1. Tap "Arc Test".
Start splicing process / Start heating cycle
3
1. Tap Set icon
Set
key
to
start
splicing process.
4. Remove the fiber from the
splicer. Center the protection
sleeve over the splice and
load the fiber in the heat
shrink oven.
Operating Procedures
Operating Procedures
2. Select fiber category.
2. After "Arc Test Ready"
appears, tap Set icon. An
arc test is started.
or press
2. Fusion splicing is completed.
the
5. Tap Heater icon
Heater key
heating process.
3. Tap the splice program you
would like to use.
* Repeat fiber preparation and arc tests
until "Good arc state." is displayed.
3. When the splicer shows
"Good arc state", prepare fiber
again
splicing process. *Fibers are
not spliced in the arc test.
3. Open the wind hood. A proof
test is automatically carried
out.
Heater progress bar
or press
to start the
*AS24F879*
to
proceed
Standby
Heating in progress
Cooling
OME1724079-9/Ver.1.00
to
the