ACTOR-MATE Crossfire AL48 Series Manuale d'uso

Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature di illuminazione ACTOR-MATE Crossfire AL48 Series. ACTOR-MATE Crossfire AL48 Series 4.

Stampa la pagina
Introduction
Thank you for selecting Crossfire. Crossfire is a four-channel DMX laser which can be
controlled via a standard DMX controller. It is a lightweight, mini intelligent fixture
and is an ideal product for discos, small clubs, exhibitions and any place that need
visionary effect. Crossfire creates exciting dual beam show with double barrel action
and four operating modes. For safe operation, read this manual before powering or
installing the fixture, follow the safety precautions listed below, and observe all
warnings printed in this manual and on the fixture.
Safety Precautions
 Do not spill liquids in to or on to your unit. If this ever happens, disconnect the main
power immediately. Do not connect this unit to any dimmer pack.
 Always disconnect from main power before making any type of connection.
 Be sure to locate this unit in a place with adequate ventilation at least 15 cm from a
wall, and mount this unit in safe and stable matter.
 To prevent fire or shock hazard, do not expose this unit to a high temperature or
high humidity area. Please unplug unit when not in use.
 Always keep combustible materials away from the fixture.
 This unit is intended for indoor use. Use of this unit outdoors voids all warranties.
 Always refer service to a qualified technician. Never look directly into laser beam.
 Occasional breaks are necessary to prevent breakdowns.
 Caution - Use of controls or adjustments or performance of procedures other
than as specified herein may result in hazardous radiation exposure!
Set Up
Unpacking
Crossfire comes with: 1 hanging bracket, 2 clamp levers, 2 washers,
1 power cord and 1 user manual. Unpack carefully and be sure that no damage
has occurred during shipping. If there is anything missing or appear to be
damaged please contact your dealer.
Power Connection Be sure the source voltage in your area matches the required
voltage for your Crossfire before plugging your unit in. Incorrect voltage selection
will detrimentally affect the operation of this product.
DMX Cable Connection Crossfire is a four-channel DMX fixture that can be
operated with universal DMX controller. This unit and DMX controller require a
standard 3-pin XLR connector for data input and data output.
Installation/Mounting Crossfire should be properly mounted by using a suitable
hanging clamp and safety cable. Use in a well-ventilated area. Be sure no
ventilation slots are blocked.
Safety Label Position
Front Panel
Laser aperture & aperture label
Left and Right Side Panel
Warning label
Control Panel Introduction
 
Bottom Panel
Certification, identification and warning label

 Power Cord Connection
 Fuse
 Power Switch
 Sensitivity Adjustment Knob
 Microphone
 DMX In & Out
 DIP Switch Pin