Sharp 530D Manuale operativo - Pagina 5

Sfoglia online o scarica il pdf Manuale operativo per Forno a microonde Sharp 530D. Sharp 530D 32. Home use carousel microwave oven

Stampa la pagina

U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S

Unpacking and Examining Your Oven

Remove:

1. all packing materials from inside the oven cavity;

however, DO NOT REMOVE THE WAVEGUIDE

COVER, which is located on the right cavity wall.

broken or loose door hinges and latches and dents in-

side the cavity or on the door. If there is any damage,

do not operate the oven and contact your dealer or

SHARP AUTHORIZED SERVICER.

Choosing a Location for Your Oven

You will use the oven frequently so plan its location for

ease of use. It's wise, if possible, to have counter space

G R O U N D I N G I N S T R U C T I O N S

This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding plug.

It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National

Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding reduces risk of

electric shock by providing an escape wire for the electric current.

WARNING

– Improper use of the grounding plug can result in a risk of electric shock.

Electrical Requirements

The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more

protected electrical supply. It is recommended that a separate circuit serving

only this appliance be provided.

The oven is equipped with a 3-prong grounding plug. It must be plugged into a

wall receptacle that is properly installed and grounded. Should you only have a

2-prong outlet, have a qualified electrician install a correct wall receptacle.

A 3-prong adapter may be purchased and used temporarily if local codes allow.

Follow package directions.

A short power-supply cord is provided to reduce risk of becoming entangled in

or tripping over a longer cord.

Extension Cord

If it is necessary to use an extension cord, use only a 3-wire extension cord that

has a 3-blade grounding plug and a 3-slot receptacle that will accept the plug on

the microwave oven. The marked rating of the extension cord should be AC 115-

120 volt, 15 amp. or more.

Be careful not to drape the cord over the countertop or table where it can be

pulled on by children or tripped over accidentally.

Notes:

1. If you have any questions about the grounding or electrical instructions,

consult a qualified electrician or service person.

2. Neither Sharp nor the dealer can accept any liability for damage to the oven

or personal injury resulting from failure to observe the correct electrical

connection procedures.

Radio or TV Interference

Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave oven

is on a different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check position and

signal of receiving antenna.

Read enclosures and SAVE

the Operation Manual.

2. the feature sticker, if there

is one, from the outside of the

door.

Check the oven for any dam-

age, such as misaligned or

bent door, damaged door

seals and sealing surfaces,

on at least one side of the oven. Allow at least 2 inches

on the sides, top and at the rear of the oven for air

circulation. Do not place or install the oven in any area

where heat and steam are generated; for example,

next to or above a conventional gas or electric range

or above a conventional wall oven. Heat and steam

may damage the electronics or the mechanical parts of

the oven.

Built-in Kit

Your oven can be built into a cabinet or wall—not

near or above a heat source—using Sharp's Built-In Kit

RK-51 (black) for the R-530DK; the RK-51W (white) for

the R-530DW; the RK-46K (black) for the R-430DK and

R-430DQ and the RK-46W (white) for the R-430DW. If

your dealer does not stock the kit, it can be ordered

directly from the Sharp Accessories and Supplies

Center. Have your credit card number available and

call toll-free: 1-800-642-2122 for ordering the kit to be

sent to your address.

The kit includes ducts and finish trim strips and easy-

to-follow instructions for installation as well as the

location of the power supply.