Sharp Carousel R-1514 Manuale di servizio supplementare - Pagina 2

Sfoglia online o scarica il pdf Manuale di servizio supplementare per Forno a microonde Sharp Carousel R-1514. Sharp Carousel R-1514 33. Over the range stainless
Anche per Sharp Carousel R-1514: Opuscolo e specifiche (8 pagine), Manuale di istruzioni per l'installazione (40 pagine), Manuale di cucina (32 pagine), Opuscolo e specifiche (5 pagine), Manuale di istruzioni per l'installazione (9 pagine), Specifiche tecniche (2 pagine), Manuale di servizio supplementare (33 pagine), Manuale di cucina (32 pagine), Manuale (40 pagine)

R-1514

PRECAUTIONS TO BE OBSERVED BEFORE AND

DURING SERVICING TO AVOID POSSIBLE EXPO-

SURE TO EXCESSIVE MICROWAVE ENERGY

(a) Do not operate or allow the oven to be operated with the door open.

(b) Make the following safety checks on all ovens to be serviced before activating the magnetron or other

microwave source, and make repairs as necessary: (1) interlock operation, (2) proper door closing, (3) seal

and sealing surfaces (arcing, wear, and other damage), (4) damage to or loosening of hinges and latches,

(5) evidence of dropping or abuse.

compartments, check the magnetron, wave guide or transmission line, and cavity for proper alignment,

integrity, and connections.

(d) Any defective or misadjusted components in the interlock, monitor, door seal, and microwave generation

and transmission systems shall be repaired, replaced, or adjusted by procedures described in this manual

before the oven is released to the owner.

(e) A microwave leakage check to verify compliance with the Federal Performance Standard should be

performed on each oven prior to release to the owner.

Before servicing an operative unit, perform a microwave emission check as per the Microwave

Measurement Procedure outlined in this service manual.

If microwave emissions level is in excess of the specified limit, contact SHARP ELECTRONICS

CORPORATION immediately @1-800-237-4277.

If the unit operates with the door open, service person should 1) tell the user not to operate the oven

and 2) contact SHARP ELECTRONICS CORPORATION and Food and Drug Administration's

Center for Devices and Radiological Health immediately.

Service personnel should inform SHARP ELECTRONICS CORPORATION of any certified unit

found with emissions in excess of 4mW/cm

the unit until the oven has been brought into compliance.

BEFORE SERVICING

. The owner of the unit should be instructed not to use