Sharp Carousel R-1874 Manuale di istruzioni per l'installazione - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Forno a microonde Sharp Carousel R-1874. Sharp Carousel R-1874 8. Over-the-range microwave oven/hood system
Anche per Sharp Carousel R-1874: Manuale operativo (32 pagine), Opuscolo e specifiche (8 pagine), Opuscolo e specifiche (5 pagine), Manuale di servizio supplementare (20 pagine), Manuale operativo (32 pagine)

10 OVEN INSTALLATION

THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING

INSTRUCTIONS FOUND ON BOTH TEMPLATES.

READ AND FOLLOW MOUNTING INFORMATION ON BOTH TOP CABINET AND WALL TEMPLATES.

MOUNTING PLATE

1. Separate 4 Toggle Bolts 2, packed in the INSTALLATION HARDWARE, from the Toggle Nuts.

2. Use Wood Screws 1 to attach Mounting Plate to the stud or studs. Use Toggle Bolts to attach Mounting

Plate through the holes at A, B, C and D; UNLESS THOSE HOLES ARE LOCATED ON THE STUD. Insert

one Toggle Bolt into A, B, C and D where appropriate (these correspond to the holes of the Wall Template)

and put the Toggle Nuts onto the Toggle Bolts. Figure 18.

Refer to instructions in Wall Template.

3. Position the Mounting Plate with the Toggle Bolts attached at the wall location and insert Toggle Nuts and

Bolts through the holes in the wall with the Toggle Nuts closed. Figure 19. Use Wood Screws 1 to attach

the Mounting Plate to studs.

NOTE: Before insertion, be sure you leave a space more than the thickness of the wall between the Mounting

Plate and the end of each of the Toggle Nuts (in the closed position). If you do not leave enough space, the

Toggle Nut will not be able to open on the other side of the wall. Also, once a Toggle Nut opens, it cannot be

withdrawn from the hole; therefore make sure all of the Toggles are in the correct position before insertion.

4. Align the Mounting Plate carefully and hold in position while tightening Toggle Bolts. Pull Toggle Bolt toward

you and turn clockwise to tighten. Figure 20.

Mounting

Plate

Figure 18

MOUNTING OVEN TO THE WALL

Two people are recommended to attach the Microwave

Oven/Hood to the Mounting Plate.

1. Place cut portion of carton (B) on top surface of range.

Protection of the range cooking surface is recommended. A

protective drop cloth may also be used to cover the top of

the range.

2. Place carton portion (C) on portion (A); then place oven as

shown in Figure 21.

3. Place the oven and the carton portions together on the top

of the range covered with (B). Slide carton portion (A)

toward backsplash until stops. Align the lower back edge of

the oven with the mounting plate.

Space more than

wall thickness

Figure 19

Wall

Figure 20

(C)

(A)

Figure 21

(B)