Crestron TMK-4L Manuale di installazione - Pagina 6
Sfoglia online o scarica il pdf Manuale di installazione per Cremagliere e cavalletti Crestron TMK-4L. Crestron TMK-4L 12. Trim ring mount kits
Anche per Crestron TMK-4L: Manuale di installazione (16 pagine)
Stampa la paginaTrim Ring Mount Kits
4 • Trim Ring Mount Kits: TMK-4L & WMKT-4L
NOTE: When installing into the PMK-4L, verify that the 18 AWG bus wire
securing the cables for the touchpanel remains attached.
1. Verify that the rectangular cutout in the drywall is as level as possible.
2. Insert the symmetrical trim ring into the opening, as shown in the following
diagram.
Insert Trim Ring into Opening
NOTE: The required PMK-4L or BB-4L is not shown.
3. When the trim ring is in position, bend the top two flanges of the ring
upward and the bottom two flanges downward.
•
If mounting into the PMK-4L, bend the flanges approximately
90 degrees.
•
If mounting into the BB-4L, bend the flanges back as far as
they can go.
4. Run the necessary cables for the touchpanel and secure them behind the
drywall.
5. The TPS-4L can be installed using the four tapped holes in the PMK-4L or
BB-4L. Refer to the latest revision of the TPS-4L Operations Guide (Doc.
6449) or the TPMC-4L Operations Guide (Doc. 6450) for details.
CAUTION: Allow an air gap of at least 12 inches in the wall cavity above and
below the touchpanel for heat dissipation.
Crestron TMK-4L & WMKT-4L
IMPORTANT
MAKE DRYWALL CUTOUT AS LEVEL AS
POSSIBLE. MOUNTING PLATE ALLOWS
ONLY MINOR ADJUSTMENT OF THE
TOUCHPANEL.
TRIM RING (2013241)
Installation Guide – DOC. 6390