Sharp CD-C4400 Series Manuale tecnico - Pagina 5

Sfoglia online o scarica il pdf Manuale tecnico per Impianto stereo Sharp CD-C4400 Series. Sharp CD-C4400 Series 12. 3-disk rotary type changer

TRAY~

UP/DOWN CAM

-.. - e - - - - + - -

TRAY LOCK PIN

MTR POWER OFF

160 OPEN

STOP

5=2

MA I N GEAR TO FREE

MTR STOP FOR DELAYED OF

TURNING D/T

PH1;ON

5·5

ZENE8A PIN TO TOUCH

5=6

Fig. 5-1 : The tray is completely open. At [AJ, the lower gear with larger diameter engages with the rack gear on the left side of the tray.

Tray Open

) ON : Low level

Press either the Open/Closekey or the tray to turn SW1 OFF(HIGH). Then MTR1 starts rotating clockwise. By the clockwise

rotation of the main gear, the tray is moved to close.

Fig. 5-2 : When the main gear rotatesto this position, the tray lock pin begins to enter the guide of the main gear. If the pin further enters

the inner part, the tray is locked in the close state.

Fig.

5-3 :

The main gear has rotated further in comparison with the condition shown in Fig.

5-2.

Fig.

5-4 :

When the main gear rotates to this position, the rack gear of the tray and the pinion gear of the main gear are disconnected.

Thereafter the tray is moved

the tray lock pin.

Fig. 5-5 : The tray is completely closed at this position. When the Close

) is ON, MTR1 will stop until the turntable moves to the

regular position. If the CD mechanism moves up while the turntable is not at its regular position, the turntable will collide with

the mechanism. When the turntable moves to the regular position, MTR1 starts rotating again to advance to

the

next step.

Fig. 5-6 : The Zeneba pin set in the main gear begins to contact the Up/Downcam to move the CD mechanismup/down. At this position,

the CD mechanism starts moving up.

-5-