Sharp AL-1035-WH A Manuale operativo - Pagina 7
Sfoglia online o scarica il pdf Manuale operativo per Stampante All in One Sharp AL-1035-WH A. Sharp AL-1035-WH A 50. Digital multifunctional system
Anche per Sharp AL-1035-WH A: Manuale di avvio (28 pagine)
Stampa la pagina
POWER ON AND OFF
The power switch is at the right side of the machine.
POWER ON
Turn the power switch to the "ON"
position.
"ON"
• Upon the startup of the machine, or when the [CLEAR] key (
Note
to its initial settings. When the machine is restored to its initial settings, all the settings and selected functions
will be cancelled.
• If no operation is performed in 3 minutes, the machine will automatically enter auto power shut off mode.
• When the machine restores to the initial status after resolving the misfeed, do not turn off the power supply.
Auto power shut off
The auto power shut off mode helps to reduce the total power consumption and the running cost. It also helps to
save natural resources and reduces environmental pollution.
If no operation is performed in 3 minutes when the machine is on, the machine will automatically enter auto power
shut off mode (The 100% ratio indicator will flash, and all the other indicators will be off). To restore normal
operation, press any key on the operation panel. The normal mode will be resumed when the machine receives any
printing task.
Initial setting
Upon the startup of the machine, or when the [CLEAR] key (
untouched for 1 minute after finishing a task, the machine will be restored to its initial settings.
Copy ratio: 100%, Exposure:3
Copy count: 0, All special copier modes: OFF
It takes about several
seconds for the machine
to warm up. The machine
can start copying only
after warm-up.
However, you can
change settings and
press the [COPY
START] key (
) during
warm-up. The copying
will start immediately
after warm-up.
POWER OFF
Be sure to turn the power switch to the
"OFF" position when it is not being used.
"OFF"
) is pressed twice, the machine will be restored
)is pressed twice, or when it has been left
6
When the machine is
powered off during an
operation, misfeed may
occur, and the task being
processed will be
cancelled.