Adjusting the colour balance (additional information for Step 6 on the previ-
ous page)
Test pattern 1 (printed by printer)
Low Density
C
M
Y
Bk
Column 1
1
Place the colour chart on test pattern 1 and compare the colours.
For the placement of the colour chart, see page 4.
2
In column 1 of test pattern 1, locate the colour density level that is the same as "1" in the colour
chart. Mark that level with a pencil or pen to help you remember it.
If none of the levels in column 1 match "1" in the colour chart, do the following:
• If the density level of "1" in the colour chart is darker than the maximum value (+4) in column1, mark "+4"
in column 1.
• If the density level of "1" in the colour chart is lighter than the minimum value (-4) in column1, mark "-4" in
column 1.
3
Repeat the above step for columns 2 through 12 of test pattern 1, comparing each column with the
corresponding colour in the colour chart.
4
Enter the levels that you marked on test pattern 1 (each level corresponds to a value from +4 to -4
as indicated on the right ) in the following screen (the screen in Step 6 on the previous page).
Y M C Bk
LOW AREA
How to use the keys in the screen
: Use the
AREA" or "HIGH AREA" that you wish to adjust.
: Use the
in the standard colour chart.
: Use the
+ALL
: To adjust all values simultaneously, select "ALL" with the
with the
5
Perform Step 7 on the previous page.
If you selected "+4" or "-4" for a colour that does not have a density level that matches the level in the co-
lour chart, repeat steps 5 through 7 on the previous page.
6
Mid Density
High Density
C
M
Y
Bk
C
M
Y
Bk
Column 12
Colour density level
Y M C Bk
MIDDLE AREA
and
keys to select the colour (Y,M,C,or Bk) in "LOW AREA", "MIDDLE
and
keys to select the density level (+4 to -4) that matches the density level
key to return all values to the default settings.
and
keys.
Colour Chart (included with printer)
Y M C Bk
ALL
HIGH AREA
key and then adjust the values
Stampa la pagina