Sharp AR-M165 Manuale operativo - Pagina 5

Sfoglia online o scarica il pdf Manuale operativo per Stampante All in One Sharp AR-M165. Sharp AR-M165 35. Digital copier
Anche per Sharp AR-M165: Manuale di riferimento rapido (44 pagine), Manuale d'uso (3 pagine)

Stampa la pagina

Click the [Print] button ([OK] button in

Windows 95/98/Me/NT 4.0).

Printing begins. When printing begins, the Print

Status Window automatically opens.

OUTLINE OF THE PRINT STATUS WINDOW (page

10)

The print job is delivered to the output tray, with

the position of the paper offset slightly from the

previous job (offset function).

IF THE TRAY RUNS OUT OF PAPER DURING PRINTING

Add paper to the tray that ran out or to the bypass tray. If you add paper to the bypass tray, press the [PRINT] key on

the machine to switch to printer mode and select "BYPASS-TRAY". Printing will resume. Note that if the "AUTO

TRAY SWITCHING" setting is selected in the "PAPER SIZE SET" (accessed by pressing the [SPECIAL

FUNCTION] key) and there is the same size of paper in another tray, the machine will automatically switch to the

other tray and continue printing.

PAUSING A PRINT JOB

To pause a print job, press the [PRINT] key on the machine to switch to printer mode and then select "OFFLINE"

with the [

] key. The machine pauses the print job and then goes offline.

• To cancel a print job, press the [C] key (

• To resume printing, select "ONLINE" with the [

WHEN "PAPER SOURCE" IS SET TO [AUTO SELECT]

If "Paper Source" is set to [Auto Select] in the [Paper] tab of the printer driver setup screen and the correct size of

paper for a print job is not loaded in the machine, the printing procedure will vary depending on the "FORCED

OUTPUT OF PRINT" setting

When "FORCED OUTPUT OF PRINT" is disabled

Add paper to the bypass tray, press the [PRINT] key on the machine to switch to printer mode, and select

"BYPASS-TRAY". Printing will resume.

When "FORCED OUTPUT OF PRINT" is enabled

The closest size of paper in a tray other than the bypass tray will be used for printing.

When the dual function board is installed

Note

• If the print image is in a different orientation than the paper, the print image will be automatically rotated 90

degrees to enable correct printing on the paper. (Other than the bypass tray)

When the dual function board is not installed

• Be sure to set each tray's paper size in "Set Tray Status" in the "Configuration" tab of the printer driver setup

screen. See "CONFIGURING THE PRINTER DRIVER" in "3. TROUBLESHOOTING AND USEFUL

INFORMATION" in the "Software setup guide".

When printing, be sure to specify a tray other than "Auto Select" in "Paper Source" in the "Paper" tab of the

printer driver setup screen.

HOW [BYPASS TRAY] AND [BYPASS MANUAL] DIFFER

IN THE "PAPER SOURCE" SETTINGS

There are two bypass tray settings in "Paper Source" in the [Paper] tab of the printer driver setup screen:

• When [Bypass Tray] is selected, the print job is automatically printed on the paper in the bypass tray.

• When [Bypass Manual] is selected, the print job is not printed until paper is inserted into the bypass tray. If paper

is already in the bypass tray, remove the paper and then re-insert it to begin printing.

] key.

(page 26)

in the key operator programs.

When the job separator tray is

Note

installed

The output tray can be selected when

selecting print settings at the time of

printing. To change the tray selection, select

the desired tray in "Output" in the [Paper]

tab of the printer driver setup screen.