Sharp AR-M208 Manuale d'uso della chiave - Pagina 18

Sfoglia online o scarica il pdf Manuale d'uso della chiave per Stampante All in One Sharp AR-M208. Sharp AR-M208 24. Digital laser copier/ printer
Anche per Sharp AR-M208: Manuale di servizio (32 pagine)

Stampa la pagina

KEY OPERATOR PROGRAMS

Disable Auto Power Shut-off

The auto power shut-off mode is used to turn off the power to the fuser automatically once a

programmed length of time has elapsed without any copier operation after the last copy of a run is

made or power is turned on. This mode lowers the user's electricity bill, reduces waste of natural

resources, and cuts down on environmental pollution.

Depending on how the machine is to be used, you may wish for some reasons to disable this mode.

This can be done using this program.

NOTE:

Since we would like you to fully understand the purpose of this mode, we suggest that you

enable this mode and set the most appropriate time using program "AUTO POWER OFF" (page

13).

To disable the auto power shut-off mode, highlight "DISABLE AUTO

POWER SHUT-OFF" and press the OK key to display a check mark in the

check box.

To restore the mode, select this program and press the OK key again to

clear the check mark in the check box.

Disable Beep at Key Touch

This program is used to enable or disable the beep function. If this function is enabled, a beep sound

will be produced when you press a key on the operation panel.

To disable the beep function, highlight "DISABLE BEEP AT KEY TOUCH"

and press the OK key to display a check mark in the check box.

To enable the beep function, select this program and press the OK key

again to clear the check mark in the check box.

Disable Backlight Change

If backlight color change is enabled, the color of the backlighting of the display varies with the copier

status as shown below:

Green: Normal

Yellow: Toner is low or maintenance will be needed soon

Orange: The copier cannot operate because of a misfeed, no toner or some other malfunction.

This program is used to disable the function that changes backlighting color. (Backlight color change is

disabled in the factory default setting.)

To disable change of the backlight color, highlight "DISABLE BACKLIGHT

CHANGE" and press the OK key to display a check mark in the check box.

To enable the function, select this program and press the OK key again to

clear the check mark in the check box.