Sharp SJG2351FS Manuale d'uso e istruzioni per l'installazione - Pagina 8
Sfoglia online o scarica il pdf Manuale d'uso e istruzioni per l'installazione per Frigorifero Sharp SJG2351FS. Sharp SJG2351FS 20.
Stampa la pagina
INSTALLATION INSTRUCTIONS
INSTALLATION LOCATION
• This refrigerator is designed for indoor, household use only.
• Keep away from heat and avoid direct sunlight or places near
a heat source, such as an oven or a radiator.
• Do not place the refrigerator in moist or watery places to
prevent rust or reduction of insulating effect to affect the
electrical insulation properties of the refrigerator.
• The refrigerator is placed in a dry and well-ventilated indoor
place.
• The ground shall be flat, and sturdy (rotate the adjustable leg
left or right to adjust for leveling if unstable.)
• The temperature of the location ranges from a minimum of
55°F to a maximum of 110°F. However, for better energy
usage and superior cooling, the temperature is preferred to
be between 60°F and 90°F.
• For proper air circulation and electric connections, allow a
3/4" clearance on each side and behind the refrigerator. Allow
a 3/8" clearance at top of the refrigerator.
• Spare enough space for convenient opening of the doors and
drawers, especially when the refrigerator is installed next to
a fixed wall to allow the door to swing open.
DISASSEMBLY OF REFRIGERATOR
DOOR /DRAWER
In some cases you need to remove the fridge doors and freezer
drawers to move the refrigerator through a doorway. The doors
and drawers can be removed by the following steps. If not
necessary, DO NOT remove the doors and drawer.
1. Use screwdriver to remove the 2 pcs screws, and then remove
the upper hinge cover of the Left door. See Figure 1.
2. Use the screwdriver to loosen the 3 screws and 1 earth screw
fixing the upper hinge, then remove the plug terminal and
then remove the Left door body. See Figure 2.
3. For the Right door, there is no earth screw. Follow the rest
of the steps for the Left door.
Figure 1
4. For a drawer, first remove the security block for the stopper
by hand. See Figure 3.
5. Press the lock buttons of both the left and right glide rails
and slowly pull the drawer out. See Figure 3.
Note:
To install the drawer in place, inserting the glide rails in the rail
housing and slowly push the drawer toward the back.
Make sure that the rail assemblies are securely installed and put
the security blocks on the lock buttons.
LEVELING THE REFRIGERATOR
Precautions before operation
1. Information in the Instruction Manual is only for reference.
2. Adjusting procedures, see Figure 4:
Figure 2
8
The security
block
Lock button
Figure 3
Before operation of accessories, it shall be ensured that the
refrigerator is disconnected from power. Before adjusting
the leveling feet, precautions shall be taken to prevent any
personal injury.
A. Turn the feet clockwise to raise the refrigerator.
B. Turn the feet counterclockwise to lower the refrigerator.
C. Adjust the right and left feet based on the procedures
above to a horizontal level.
Schematic diagram of the leveling feet.
Lower
Higher
Figure 4