Shimano Bell Crank III Istruzioni di servizio - Pagina 4
Sfoglia online o scarica il pdf Istruzioni di servizio per Accessori per biciclette Shimano Bell Crank III. Shimano Bell Crank III 4.
Stampa la pagina
Adjusting bell crank
1.
Set the Revo-shift lever to
Next, turn the cable adjusting bolt
until the red line on the push rod
is aligned with the end of the hub
axle.
Set to
2
The red line on the push rod and the end of
the hub axle should be aligned.
End of hub
axle
Red line on
push rod
If the red line on the push rod is not visible, adjust so
that the yellow section of the link is between the two
yellow lines on the window.
2.
While turning the crank arm, move the Revo-shift lever from
1
and then from
1
back to
gear shifting.
Set the Revo-shift lever back to
the push rod is aligned with the end of the hub axle.
If they are not aligned, turn the cable adjusting bolt to make
fine adjustments.
3.
After adjusting the bell crank, tighten the cable adjusting nut to
secure the cable adjusting bolt.
Cable adjusting nut
2
.
Cable adjusting
bolt
SET
Yellow line
Yellow line
Yellow section
SET
of link
Note:
Look at the two yellow
lines from directly above
during adjustment.
two or three times to check the
3
2
and check that the red line on
SET
Securing the shifting cable to the frame
Secure the cable to the frame with the outer casing bands.
20 – 25 cm
Push rod
These service instructions explain how to use and maintain the Shimano
bicycle parts which have been used on your new bicycle.
For any questions regarding your bicycle or other matters which are not
related to Shimano parts‚ please contact the place of purchase or the
bicycle manufacturer.
Please note: Specifications are subject to change for improvement without notice. (English)
One Holland Irvine CA 92618 U.S. A. Phone 9 49 -9 51 -5 00 3
Industrieweg 24 NL-80 71 CT Nunspeet‚ Holland Phone 3 1-3 41-2 722 22
3-7 7 Oimatsucho‚ Sakai‚ Osaka‚ Japan Phone 072 2-23 -324 3
Mar. 2000 by Shimano Inc. PIT. SZK. Printed in Singapore
C
3
to
There should be enough
slack so that the cable is
not pulled too much
when the handlebars
are turned.
Outer casing bands